chitonan,
>Hi, Bib i got the bib starter I use to hang with the original Bib, and i decided to try the starter to see if it would fit better since the original bib is kinda big in the sense that it’s too close to my head when i hang, and if i go over 5lbs it slides down to my head and over it.<
That would mean you were using the regular with it not tight enough. Remember, wrap loose, hanger tight.
>Well i gave bib starter a tr, the problem i have is, since it is so short length wise, where in the shaft should i place it? Should i attach it more towards the head or more towards my body?<
Start out attaching the hanger about one inch behind the coronal ridge. See how you like that. Then, experiment from there to find what you like best. I always moved my attachment point around. Closer to the base to get more skin stretch for a couple weeks, then closer to the head to stretch the internal structures. Divide and conquer.
>Also i am hanging straight down and the hanger seem to pull on my ligs so much that my head points points almost straight in font of me, almost at a 90 degree angel with my shaft (maybe not that much but a lot more than the original, is that bad?<
That is the way it is supposed to work. The slight angle gives more gripping power to the hanger. However, it should not be severe. If too severe, you are not placing your shaft low enough in the shaft well. Be sure your bottom adjustments are wide enough, and that you open the hanger completely when you place your shaft in it.
>Also i can never fully get the blood out of my shaft, and when i hang my head is always filled with blood, can you give me some tips on how to get the blood out of my head?<
Sure. The easiest thing to do is to wrap completely, let any erection subside for a couple minutes, then push or pull the wrapped bundle over the head a little and squeeze. This will allow any trapped blood to move toward the base. Then attach the hanger immediately.
Hope this helps,
Bigger
