Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

New to vacuum hanging and have a few questions PLEASE

New to vacuum hanging and have a few questions PLEASE

Hi all.

I started vacuum hanging. I got a set on Wish which includes 3 blue caps (I’m sure you all know the ones).

Firstly: When using the medium cap - my dick fills it well, however.. When I vacuum pump all the air out, I feel like a pressure on my banjo and a pain after 5-10 mins to the point I take it off because it doesn’t feel right, my banjo is a little enflamed after finishing also. I wrap with 3m micro tape, then use a plastic little cap to go over the head, and then I put it in the cap.

QUESTION: In the caps there is a little arrow, I’m not sure which way I’m supposed to put the cap on, the dimensions are different. In the cap. Logic says that arrow should be on the bottom, but I have less pain when the arrow is on the top.

Second point is, when I use the larger cap, I have less pressure on the head itself however, the plastic sheath ends up getting sucked into the cap slightly - is this a problem or is it fine? I’m guessing because it’s slightly too big.. But I don’t have as much pressure.

My issue is that my dick is really quite thick, especially when erect so the head which initially fits in the cap, once it’s vacuumed it swells to a much much bigger size which causes that pain on my head. If I pump only a few times, it fills the cap better and I don’t have much pressure, but I am worried that because some air is still left in that it may cause blisters and damage which I really want to avoid. Is pumping just enough okay also? Or does ALL air needs to be vacuumed, like the more I pump it, the more pain I have with the medium cap. I do not get this pressure with the large cap, BUT I can see that there is space in the large cap between my penis head and the end of the cap - so I really don’t know which one to use.

To be honest I think I am right inbetween a medium and a large cap which is quite annoying for the perfect fit.. But the caps only seem to have three sizes. Tips and advice appreciated.

Bump.

Have you read through any of the LGhanger threads? They discuss wrapping the glans to better fit the vac caps on.

Any of you vac hanger users have any thoughts?

This is not an area of PE I have any experience in so do not have any guidance to share.


Initial: 7” BPEL; 6” NBPEL; 5.25” - 5.5” MEG

Current: 7-7/8” BPEL; 7-3/8” NBPEL; 8.5” BPFSL; 6.5” MEG; 6”x5” Flaccid.

Goal: Improved/consistent EQ while managing ED. Secondary: maintain current stats.

So I’m not sure which vac system you are using. I will say any pain is bad so I’m not sure if you’re wearing it properly.

When I suck the air out of my vachanger I try to get all the air out. My sleeve doesn’t get pulled into the cap at all.


Short-Term Goal: 10.25" BPEL

"Take it Slow and Watch it Grow"

Long-Term Goal: To Be Decided

I think that’s because I’m using the larger capso my head doensn’t seal it, but the larger cap doesn’t give me pressure pain on my head like the medium cap does

Same problem here, it was a matter of time I got used to. I began hanging 5 minutes and increasing my sessions length up to 30 minutes. Doing that way I conditioned my unit to the vacuum, which is not that much actually.

I am doing 3 sessions 30 minutes each with 6.5 lbs.

I use a total man hanger. I use the large cap with no problems or pain.

Are you wrapping/taping before using the cup?


BPEL: 5.5" --> 7.9" ; BPFSL: ~5.6" --> 8.5"

Progress log summary: Hanging with FIRe

"Going hard, fast and heavy is all against the scientific knowledge of tissue expansion or elongation." - Kyrpa

Top

All times are GMT. The time now is 01:49 PM.