2x10 tube

I just received my 2x10 tube from LA. It looks really big (girth) and was wondering how I can tell if it is the correct size? What should the diameter be? Thanks.

Uhhh…try it? That’s the way I checked mine…however pi*diameter= 6.25” internal circumference so I doubt you’ll fit in there. I’m 5.75 at mid shaft x 6.3 base and use a 2.25” now.

The inside diameter should be 2.0 inches.

Thanks gprent, I’ll check it out.

Wow, the internal diameter is 2”. It just looks so big, maybe my perception is off…I’m also a lot flatter, not so cylindrical, maybe that’s why it looks so big. Oh well. Thanks.

A 2.0” diameter tube is big = 6.28” girth. When I first got mine, “packing” it seemed like the impossible dream. But it happened over time, and now I’m in a 2.5”.

Peforeal

peforeal,

The thing is, my girth is at least 6.25 mid but the thing still looks huge. I am tapered toward the head, significantly, and my unit is wide…maybe 2.5 inches, but flatter from top to bottom. Maybe that’s why it looks so big, it is rounder.

rushmore,

The 2” size is still right for you. You’re wider across the top (horizontal), rather than wider across the sides (vertical). I’m opposite and am wider down the sides. Most of my girth increases over the years have come on the underside of my dick, which is why my measuring tape girth measurements continued to change while the view of my dick from the top seemed not to change as much to me. We’re all differently shaped. I look much bigger from a side angle than from a top/down position. I also taper a lot toward the glans and widen up signifcantly toward the base in both flaccid and erect size.

Hopefully, through pumping you’ll widen and expand more in the areas of your dick where it’s needed. You’ll see how your dick reacts in pumped size through your own experimentation.

Peforeal