Black and blue
I’ve just started the whole PE-thing a bit over a week ago with the Bathmate and so far the results have not been that good. Pretty much the only time that I had good results with using the BM was the first time. My penis was a good, natural colour (maybe even a bit red) and felt very thick and engorged even when flaccid and the results lasted for a long time. But after that every single time I’ve pumped (I do it once a day for 20 minutes) the results have been poor. My unit has had a very blueish tint to it when I remove the BM and sometimes, when I’ve pumped really hard, it has been almost black upon removal. The discolouration disappears fast but so do the gains from using the Bathmate. I mean, the penis is huge when I remove it from the unit but after only like 30-60 seconds it returns to normal, including it’s colour, and it’s not at all as full as it was after the first time I used the product.
Now the odd thing is that, reading from the measurements on the BM, the amount I’ve pumped has varied like this:
1st time: 175
170
170
180
185
185 (this is where my penis was almost black for a short while and my EQ was poor for a few hours)
175
170
Last time: 165
So after noticing that 185 was definitely bad and that increasing the pressure did not help increase the results, I’ve constantly been dropping the pressure while keeping the session time at 20 minutes but there’s still odd discolouration and no results even after reducing the pressure to less than it was the first time.
I guess that the next logical step is to decrease the time I use the Bathmate and see if that would help but this is still really annoying because I *did* get really good results the first time but I’ve failed pretty much every single time after that.Has anyone else experienced this?