heat wrap and pumping

hey guys,

i’ve been pumping for a bit more than a month. I’m starting at 7x6.25 and want to hit a very thick 9 incher.

After reading here a bit, i went and bought a heating pad. i got one that is 6x10 inches, which wraps great around my vacuum tube.

I’ve gotten great results! the warmth feels great, and my 6.25 gets way fatter.

Just thought I’d share.

oh.. any other uncut pumpers or PE-ers wanna share ideas, tips and challenges in all this PE stuff?

Hey Welcome aboard!

Anyhow, I assume you warm up first with some device be it a rice sock, wet rag, electric blanket. Then you go right into the pump. Is it high or low vac? Is there water inside for better heat transfer? I remember reading it somewhere in the pumper’s forum about this. Anyhow, do you keep the electric blanket on the whole time you are inside the pump?

Sorry for the million questions there! Thanks TT

ok.. i’ll do my best to answer. Remember, I’m new to this. So, i may be learning along with you.

“warm up first with some device be it a rice sock, wet rag, electric blanket.”

I use a warm, wet washcloth and often lift some weights to get my blook pumping.

“Then you go right into the pump. Is it high or low vac?”

Then I jelq and pump, then jelq and pump, and last time.. you guessed it- jelq and pump.

“Is there water inside for better heat transfer?’

No water in tube. I might try that.

“Anyhow, do you keep the electric blanket on the whole time you are inside the pump?”

It’s not an electric pad. It’s one you throw in the microwave. It’s good because it cools with time and it would be hard to scald the cock.

Thanks! I do appreciate it! We are all learning from each other here. TT

I’ve used a heating pad, “electric” while in the pump ever since I started my long session/low pressure techniques. I had the heating pad idea after I noticed that my penis was rather cold during and after pumping…not good for circulation. All you have to do is rest the heating pad on top of the pump and the temperature inside the pump will increase dramatically. I imagine that a rice sock or hot towel would suffice but is also a pain in the ass after awhile… Exactly how long does a rice sock keep its heat?

About ten minutes, in my experience, depending on how much rice is in the sock.

However, holding a rice sock around a cylinder with you in it is a cumbersome process and, if the rice is newly heated, the acryllic tube can become dangerously hot with potential for burns.

I think SlimJim’s suggestion of a heating pad makes better sense (assuming there is no water also involved).

P.S.: Not all pumps are compatible with water use. Check with your manufacturer before trying this. And even if your pump is water-compatible, do it in the shower or a tub. Not a neat procedure. :-)

Never again.

After 30 years of successful vacuum pumping long before any internet advice.

It easily made the tissues easier to produce my first ever small donut. Its fully healed now. If it sounds too good to be true. Don’t use the advice.

Personally I have had less negative PIs if the cylinder is heated before and during my pump routine and the heat seems to promote expansion. If I stay to 5HG and no longer than 30 minutes I don’t get any edema.