Help with cylinder size.

I wouldn’t dream of pumping w/out a gauge, can you afford to get an inline gauge from like AutoZone? If you can’t afford one, just be careful, you only have one penis. How long have you been pumping?

off and on for around 2 years. I take spells

5x5

Hi gprent! Sorry to bother you. I need some help with the cylinder size too ( LAP Dist).

My stats are:

7,4” NBP erect lenght
6,2 erect girth

What cylinder size you recommend me?

Thank you a lot!

You should look for a 10”X2.25”

I need help with tube size.
I am 7 x 5. (BPEL and widest girth point)
I don’t care if I gain any more length, but I want at least another inch in girth.

I’ve never pumped before, but I have been doing PE for a couple of years.

1.75 x 8?

If you’re already 7 L, go for a 9 or 10” tube.

I’d say 1.75 on the diameter. What you think, gprent?

King, I agree with avocet8. A 9”X1.75” should be perfect.

thanks guys, I will go for the 9” x 1.75”

I can’t wait to get started.

I too am looking to buy a pump, and would appreciate some advice on what size to buy.

My size is very similar to King_G’s.

Length: 17.5cm (~6.89in)
Mid-shaft Girth: 13.3cm (~5.24in)
Base Girth: 12.7cm (~5.00in)

I certainly to not want pumping to exacerbate the baseball effect. I assume that by not using too big of a cylinder, I could avoid doing this. Maybe it would even help correct it (which would be desirable for me.) Do you agree?

Does my shape have any impact on what size I choose? I am thinking that 9 x 1.75 would be best for me, too.

You are correct. Go with the 9”X1.75”

Thank you for your advice.

I don’t know what your shape was/is, but do you have any idea if pumping might worsen my baseball shape? I have read that most people experience the most growth at the base, but unlike me I think most people have the most girth at the base to begin with. I would prefer to make my shape to be more even, if it is possible.

I’m curious about hot water pumping. How does one get hot water into the tube but not in the pump ?

I water pump in the shower, in the bathtub and just sitting on the toilet. My tube is 9” X 1 3/4”, I marked the tube while I was fully pumped, from the base up to 6 3/4”, then I fill the water leval up to the mark on the tube which is 2 1/4”. I lube the penis and the seat of the tube, put penis in the tube and pull it tight against the pubic are, I sit down and hold the tube in a position where there is an air pocket on the very top, then I hook up the vacume line to the tube and quickly get enough of a pump to seal the base to the pubic area, then I work my way up to 4-5 Hz. Then I wrap a towel around the tube to keep the water hotter for longer. I also use hair conditioner as a lube.

If your pump has a gauge, it is probably best to forget about water pumping. For water pumping, you should use a pump like this: | LA Pump

Mine has a gauge and I haven’t had any trouble with it getting wet, you do need to be very careful though. I wouldn’t even consider pumping without gauge, it would be very easy to over do it.