How to prevent scrotum from getting sucked in

I have this constant nagging problem of my scrotum getting sucked in whenever I up the pressure beyond 5 inches of Hg in my 2” dia cylinder. And having first degree varicocele, not only is this scrotal-suction uncomfortable, it can potentially make the varicocele worse.

So, my question to all of you is, do you guys make any attempt to stop this scrotum suction? And have you come up with any effective way to prevent it, and if you have, could you please share it with me.

One idea I have thought about is to use a scrotal ring (or maybe the TheraP velcro wrap once I have it) to wrap around the base of the scrotum while pumping, and thereby keeping it out of the cylinder. Dont know if this will work, but will give it a try.

If any of you have any ideas, please do share.

thanks
-leo
(that’s used to be my userid at the old EZBoard PEForum)

Welcome back Leo. :)

Careful shaving helps at the shaft base. In fact, I got less ball sucking into the cylinder after I shaved my ball sac.

Unexpected advantages of shaving my ball sac have been more oral ball play during sex [(nobody likes spitting hairs) let along splitting them], and an overall increase in sensitivity and sensuality in that area while wearing street clothes. I don’t think I’d go back to hairy balls again.

sean_pecker,

Here’s an excerpt from a previous thread I responded to that may help you:

“To prevent extra skin stretch or an errant testicle from being sucked up into the cylinder, I cinch down my nuts by doing the following:

a) Purchase a cheap bicycle tire rubber inner tube,
b) Cut two circular 1” sections from it, stretching them out alot to increase pliability and flexibility of the rubber,
c) Lube the inside circumference of each 1” section (any kind of cream will do),
d) Stretch each section wide using fingers on both hands and place these one at a time on top of each other around the area of your ballsac between your dick and balls.

Why two and not one section? You need at least two so that the thickness of the wrapped area is firm enough not to fold over on itself. One won’t do. You can use more though, if you want. Just experiment.

What these rubber tire tube sections will do is to hold down your nuts away from the base of your dick. Even when you pump, there’s now no way they can be sucked up into the cylinder. Also, they keep the skin on your scrotum from being sucked into the cylinder, allowing for more effective pumping of your base shaft area. This is what you want ideally.

Just another personal discovery that has worked for me.”

Peforeal

peforeal,

thanks a lot for the valuable info.

Thunder, nice to get back among you veterans

-leo

I am now using a 3”[75mm] diameter tube and have no problem with my balls being sucked in.I have practiced the art of pushing both balls up into the stomach cavity.The opening of the chamber presses hard against the pubic bone and the balls cannot squeeze past between the two hard surfaces .

If you were pumping with your balls in the ordinary position[ below] they squeeze between a hard and a soft inner surface.

I hope that makes sense to someone

Sean - I use leather ball stretchers and that works great too. They have snaps on them and you can pick them up for 5-10 bucks on the net or at any adult store.

Sean,

I have no problems with my nut(s) being sucked up into my 1 3/4 x 8” cylinder. When I first started ramping up to my 2 x 9” cylinder….sucking a nut into cylinder was common place.

Now, when using 2 x 9”, I’m sitting on edge of chair (I always pump while at computer) and my nuts dangle down… I’m doing it now….I’m of the opinion that our cylinders develop synergy with our body/dick/nuts…getting cylinder positioned now I did not have to do like I did initiallly….pull down on my nuts.

Just my experiences….’

OR eon
65 yo