I'm thinking about pumping for more length...

Sounds like you are doing a good job and are plenty big, but good luck with further results!

The best thing to do is just start off with the standard work horse straight walled cylinder. Don’t worry about the gimmicks until you get totally addicted to pumping. I have been pumping for years and still find I don’t need anything other than a straight walled standard cylinder.

Thanks, I thought as much myself. I’ll probably go with the 2.25” x 10” cylinder from LapDist. Even if it’s pretty tight… I just don’t want any chance of ending up with a 7.875” girth. :)

Over 7 inch Girth!!! Do girls freak when they see that thing?

I’ll just get it out of the way now. When you come back complaining that your 2.25 is too small, well, I told you so.

OK, that takes care of that.

Sometimes, but it’s usually just me freaking that it’s not an inch longer than it is. :)

Please, don’t take my decision personally… I did listen carefully to your input, but even the LapDist website only recommends the 2.5” cylinder with a 7.875” girth.(That’s almost 8” & I don’t even want temporary girth that large…) Sure, I could use that, since it’s not that much larger than my girth, but I’d rather not risk any girth gains & I really don’t see a problem with using the 2.25” cylinder. LapDist’s own website recommends the 2.25” cylinder with a 7” girth & even though mine’s ~.3125” more than this, I believe this should be fine. After all, 7” more closely corresponds to my circumference than 7.875” & also, you must remember that length is my only goal. And, most of what I’ve read thus far, suggests that going with a smaller diameter cylinder(That will still fit over my penis…) is preferable, if length is my goal.

If not, you needn’t worry, I won’t “come back complaining” that it’s too small. What gain would there be in that? I’ll just use another alternative as my ADS. But please, don’t think that I just brushed aside your input, because I didn’t. I appreciate ALL of the information that I receive here. But, I take all of the information that I can glean from everyone here at Thunders Place & I use it to help me make a decision in my PE, I don’t let the messages make the decisions for me. The information here is but a tool, that I use to help me to find my way down the correct path. A blind man is helped[i] along the path with his cane, but the cane doesn't [i]do the walking for him.

If you were offended by my decision, or believe that I ignored your advice, then you are mistaken… Any advice that you may have, now, or in the future, is & always will be very much welcomed.

I am not offended in any way. I hope it works for you (but I don’t think so :) ). Make sure to use plenty of lube. :)

I understand your predicament and think you are going about it the wrong way, but I have been wrong before.

Maybe I’m being too pessimistic, but I have always believed the pump suppliers tend to recommend cylinders on the small size so they can sell more cylinders.