LeLuv Pump Cylinders

AndyJ, understood. I’m going to try it again tomorrow, first without any lube or added seal, then progress from there. I shaved the area a little more so I’ll see what happens, maybe I can pinpoint the place it’s not sealing at. I have the sleeve pictured, and have used it a couple times before, but it’s restrictive enough to notice the difference in girth at the base when I’m finished. That must be what they refer to as the baseball bat effect.

Upthread, you said you were less than 6" girth, but were looking at a 2-1/4" cylinder. Is that what you bought?

"Baseball bat" or "traffic cone" normally refer to your natural erect shape, not pumped or constricted.

I am 6" girth, and yes I bought the 2 1/4" cylinder. When I referred to the "baseball bat" shape I was referring to how my penis looked after pumping with that sleeve, not it’s normal shape. The sleeve constricts the base some so when I remove it after pumping it’s smaller there than the rest of the shaft.

Your tube is a bit big for your girth.

You might try making the opening of the tube smaller with a bead of silicone sealer or Shapelock thermoplastic.

In my experience, even small amounts of hair at the seal area can cause noticeable air leaks.

AndyJ, seems to be except the cheap cylinder I have is the same 2 1/4" and seals fine, but has the regular rolled lip.. Since they’re non-returnable lesson learned. I guess I’ll use it with the flange seal, but was trying to stay away from that, hence the wide-flange. Still have a few things to try though, thanks for your input.

I have a cheap 2 1/4” tube as well. I try to cleanup down there once a week or so, mostly for presentation to the misses. I have found that petroleum jelly at the base helps make a decent seal. I do press tube into my pelvic pad but once it seals works good. It does take getting use to. Oh I use the silicone cock ring. Been using maybe 6-7 months. I tried the make your own rim cushion apparently I lack the skill or patience for that task. No

Issue noted to the motorized pump from petro modified hose used from brake fluid kit. Good luck & happy pumping

Update: Shaved a little more, plus used an extra helping of coconut oil around the wide lip, seals up pretty good now. Probably should’ve went with the round flange, even though it is a 1/4" smaller i.d. at the base. Future plan maybe?

good update

Good to hear it’s working out for you

Thanks guys!

In my experience I have always found the wide flange cylinders give the best seal and comfort. I have never used a sleeve and found that simply trimming public hair enough gives a good seal for me. The only problem with wide flanges for myself is that at higher diameters they can dig into the insides of my thigh.