Packing the tube question

I just got a pump from LA Pump and have a question about ‘packing the tube’. (Don’t mean to hijack the thread, I don’t have enough posts to start a thread yet.)

I did my first session today and noticed I’m filling the tube completely side-to-side and the top appears packed too. There’s a little room on the bottom for growth but that’s it. Is that enough to encourage girth gains?

For reference I’m right at 6” erect girth at the thickest part of my shaft and I ordered a 2” tube based on the guidelines on their website. Thanks in advance for any insight you guys can provide.

Apparently you have not read the Forum Guidelines.

/faq.html?faq=t … q_tp_fg_general

I’m sorry if I violated a policy. I did in fact read the guidelines and just scanned them again and am not exactly sure which guideline I missed or violated. I’d appreciate any guidance you can offer so I can be sure not to do it again. Again, my apologies if I did in fact break a rule.

You said you don’t have enough posts to start a thread, but you can. The rules state:

-New Members can start threads in the Penis Enlargement Basics, Progress Reports and Progress Reports and Pictures forums
-Members can start threads anywhere but the Penis Enlargement forum
-Senior Members can start threads anywhere

NOTE: My poor attempt at an educational moment backfired and became a derailing event so I split this into a new thread.

If you are totally packed at the glans then your shaft may not be getting full effect of the vac pressure. You probably need to go up a size.

Ok I see now, I misread that and thought it was stating that I could post in the those threads as a new member after my initial 30 posts. My apologies, 100% my fault.

That’s what I was thinking but wanted to confirm before I reached out to the manufacture. Thanks so much for your feedback!

A true 2” i.d. tube has circumference of 6.28”. Is the tube straightwall or does it decrease in size towards the top?

It’s straight wall all the way up.

Then a 2.125” or 2.25” tube could be options for you. Leluv has them for around $40. Not sure what LAPump has.

for that girth you’ll need to look for 2.25”, maybe even 2.5” tubes if you’re looking for some length, as you will pack the 2.25 quite easily too.

What is your glans circumference? Is it larger than your 6” shaft, or is it expanding under vacuum to fill the 2” cylinder?

A 2.125” id cylinder has circumference of 6.67”
A 2.25” id cylinder has circumference of just over 7”.
A 2.5” id cylinder is 7.85” circumference.

I haven’t measured it but it’s not quite as large as the widest part of my shaft. It does not quite fill the 2” tube but it’s close. In fact LA Pump makes a cylinder that specifically targets the glans in isolation. I have an email into the owner asking if that is something I could use in conjunction with a regular cylinder, potentially alternating between the two as part of a program.

Why wouldn’t you just get one cylinder slightly larger than your largest girth?

I did, I ordered one that’s 2.25”. Was thinking of adding the mushroom tube to isolate the glans and promote stronger growth to that specific area. However I’m not sure if it’s a good idea or not, which was my reasoning for contacting the owner with that question.