Penis Pump cushion to reduce diameter

I got 1 size too big on the La pump (2.25inch shoulda got 2inch) and the sharp acrylic edges arent very comfortable for a skinny lean person either. Was wondering whether getting a cushion ring/sleeve to put over/arnd the bottom on the cylinder would kinda help both issues and any recommendations if so. Because I see alot of these cushions advertise that they don’t reduce cylinder diameter but in my case I’d actually prefer it did lol. (ik yall gonna grill me for getting the wrong size but it iz what it iz)

Looking at one on amazon says its for cylinder 2-2.5inches and no phthalates which seems good. Cheap aswell.

Posting here because it won’t let me post in the relevant section

So far I haven’t found any worthwhile seals or cushions for the 1-3/4-2-1/2” tubes. They’re all paper-thin. If you were looking for a 3” or larger seal for a full-package tube, no problem.

You alternatives are:

Buy the proper size tube from LeLuv. Get the more expensive one with the rolled bottom edge. $35-ish

Buy a tube from LA Pump, that takes their big soft seal that doesn’t fit any other brand of tube. $100-ish

Buy some Shapelock plastic and mold a large radius around the opening. $5-$10 (eBay, Amazon, or many hobby or craft shops)

I have an lapump tube. Bought the blush performace pump sleeve. Don’t rly get how it works tho.
I thought it’s just be a donut with a slit in it so it goes anrd the outer ring of the pump, whats this weird thing with folds n everything, doesnt fit cleanly arnd the pump. Am I doing something wrong?

Https ://imgur.com/a/EBeUDtX

I’ve had the same problem with my cylinder. It was way too big. I ended up moulding a sleeve out of silicone myself.

You’ll need a tube of regular silicone, a container of soapy water and a tube that would make the inside diameter that you desire.

Pump the silicone into the soapy water, this makes it less sticky and kind of like modeling clay, but much softer. Gather it together into a ball. You can then mould it around the tube until you get the desired thickness and length.

I personally moulded the inner sleeve first then the flange around my cylinder for cushion after. The soapy silicone sticks to itself very well, but seems to release from plastic quite easily.

You can also apply some Vaseline to the areas where you don’t want it to stick to help it release easier.

I now take advantage of the extra diameter of my cylinder by removing the sleeve and doing so full package pumping.

I found the VelSeal silicone gasket from PumpToys worked well on LeLuv and LA Pump cylinders - $29.