Would a 2.48" diameter pump be too big for me?

My thickness at the base is 5.5” or so.

I still do not want to use the pump until it finishes at least 4 months with the rookie routine.

The diameter table of tubes for my thickness if I want to gain thickness are 5.25 “. But it is an offer and I do not know if it is too big or it would be good.

Can you help me?

With a 5.5” base girth, a 2.48” cylinder would be too big. A 2” tube would be a better size.

Yes

Probably too big. You would have to modify the base so that it gets narrower or else there is too much room and you might not get a seal.

There are sleeves that you put at the base.

Thank you so much guys.

I think if I want thickness i could look for a tube with an additional 0.25 “in diameter.

2.25”

I think I heard DickerDickerschwanz.

It is extremely common for any man buying his first cylinder to buy one too large. I believe I still own a cylinder I can’t use. One actually so big I humiliated myself.

I would listen to the 2” diameter recommendations. Otherwise, you’re likely to slow your gains with a crappy seal.

Here you go: Selecting Your Cylinder Size

If I saw what I recommend the indications but also read the 0.25 more to gain thickness.

Your girth of 5.5 Inches is at the low end of the range, so you select the 2.0” cylinder. If you were at the high end of the range or 6.0 girth, you would select a 2.25” cylinder for girth gains.

Okay, I had doubts because sometimes I have more thickness in the base, 5.75 “or so, then I had my doubts.

Thank you so much!!

My shaft girth is about the same as yours. I have a 2 inch cylinder which is more than enough for me. After over a year of pumping, I still haven’t packed the cylinder.

Even with this, I have to be careful with my testicles being sucked dangerous close to the cylinders edge :eek: . To counter this, I have to stretch my testicles down, while increasing the vacuum.

The first couple of inches of the cylinder is packed from loose skin, and I would only suck more skin in (plus maybe testicles), if I had a larger cylinder.

My only problem is that I have a slight upwards curve, with a mushroom head. My glans are therefore squashed against the top of the cylinder. A larger cylinder would be beneficial in that respect.

However, as far as the base is concerned, a larger cylinder would probably cause more problems than it’s worth. :)

I’m really screwed. I have been given a 2,559 “pump of inferior diameter.

I can not give it back so I have to keep it. what I do?

What I can do? I can’t use it until I have 6.75 “/ 7” base girth?

Skygod, I’ve also got the upward curve and mushroom head leading to squashed glans. I just ordered a GlansXpands tube from PumpToys, hoping it will help.

Thanks FunSize.

I just had a look at that GlansXpand Tube.

It looks very comfy, compared to some of the other 2 stage cylinders I’ve looked at. I especially like the transition between stages, and the entry angle.

One of my concerns about the 2 stage cylinders was that because of my slight upwards curve, the top of my shaft would rub on the edge of the transition between stages, since the glans would no longer stop the top of the shaft from touching the top of the cylinder.

Also, getting the correct sizing is even more important than when buying a normal cylinder.

I’m very interested to hear how it goes for you, so please keep us informed. :)

As the wise men here have already guided you 2” is perfect for your dimensions. You will get to 2.5” in due course but there is more value to be extracted at the 2” cylinder.