Two Stage

So I bought a Boston two stage pump cylinder, I waited almost a month to get and the guy on the phone not so helpful. I received item and now a month later I put water in cylinder and saw a bunch of bubbles coming out of where the two cylinders meet. Wow 150 bucks for this cylinder.

Anybody have ideas how I can fix this leak like, can I use some type of silicone caulk from Home Depot

Also it gets hot in sessions with heat pad.

Real shorty work on these cylinders

Really, you should ask for a replacement on expedite, but if that looks like it would take forever, you might try this.

Mark where you see the leaks. Put the cylinder on and under vacuum pressure put a drop of Super Glue where the leaks are and the glue should get sucked into the leak and seal it. Just one drop per leak.

Just for info please copy and paste a link to that web site.

The guy I talked to doesn’t want to do squat he acts like his product has no flaw, he’s like your past your thirty day warranty, but I will still help you but I need to cover shipping there and back. And a replacement fee which hasn’t even been said how much.

Like I’m better off fixing myself.

I was thinking of super glue but too, but glue it not under vacuum right?

3.5"x5"advance series 2-stage monster cylinders by BostonPump.com

Here’s the link and photos

Here’s how I found leak a strip of bubbles

OK, I see the bubbles, but is the cylinder leaking, or does it hold pressure?

For some reason, that link just won’t work for me. I also tried just Boston Pump Adult Sex Toys - buy penis pump, penis enlargement packages, clitoral pump, toys for men at bostonpump.com and that doesn’t work for me either.

Edit: After a fairly long wait, the link finally worked.

It leaks does not hold pressure at all.

They want me to pay for shipping there and back. I’m responsible for loss or damage

A handling fee of 25 for the repair.
And pretty much a month of wait.

I’m a machinist so like there’s gotta be a way I can just repair it here. It’s not fucking rocket science.

Pumptoys looks like a better product

I know one thing, I will never order from Boston Pump! For them to deliver a defective new part and not take full responsibility to make it right is unheard of.

As far as you fixing it goes, yes, I was thinking if the cylinder was under a little vacuum pressure, the Super Glue would be drawn into the leak and seal it off and pretty much be invisible. Probably best not to use your penis as a cork though cause you don’t want to get stuck!

I think guys that repair small windshield cracks from pebble hits use a similar technique.

What should I use as a cork trying to brainstorm?Definitely gunna add water to see when the bubbles stop. Probably need a weight on top of cylinder.

I assume the cylinder is some sort of acrylic.. Supergue should work but a better solution might be to go to the hardware shop and get a locktite glue specifically designed for acrylic. Likely to be stronger.

Why a weight? Vacuum will hold it in place. I would shave a spot on my thigh and clamp it on there, then apply adhesive.

If any gets through, it’s not going to hurt bare skin. Just wash it off.

Okay thanks guys I’ll be able to try it when I get off

Glue will be dry by then

If no visible repair is desired, try some PVC cement available at the hardware store plumbing section. I have used the purple primer but would only use the clear cement now as the primer is really a strong solvent, purple and will melt the joint/crack too much. I don’t think under vacuum repair is needed but it may draw the solvent into the joint a bit. I have used this to seal three cheap cylinders that developed cracks in the tube and leaks at the thread of the fittings. Make sure the repair area is squeeky clean like with alcohol and clean wipes first. Good luck