Water pumping with traditional cylinder outside the bathroom. How do you do it?

I’ve seen pictures of men doing water pumping while sitting at a desk using a traditional air pump cylinder.

What’s the best way to go about this?

Water pumping does seem to do a better job than air pumping, though there doesn’t seem to be a clear reason why just yet. I do know that with dynamic timer pumps, it allows the vacuum to reach higher Hg more rapidly due to the water not expanding like air does.

I’ve also read some online in the past about adding salt to the water. What’s the reason for this? What does salt water improve about water pumping? And what kind of salt is used?

Any tips for water pumping in general?

I just fill the cylinder about 1/3rd full of water, lay down and get erect with the cylinder nearby, then when I’m ready I turn on my side and put myself in the cylinder, pushing it against myself to seal before turning it so much the water comes out, I can usually hold it against myself to stop water from dripping. Then I point it upwards and start pumping, I don’t even have one of those water catches but since I just keep enough water to submerge my penis, no liquid typically gets pumped into the tubing. I guess I’m always laying down doing it, so wouldn’t work the same for a desk, but similar strategy could be applied.

I had a close call trying it at a desk yesterday. I don’t want to find out what happens when water gets sucked into an electric pump. I have an inline water reservoir I could use, but I don’t want the added space not occupied by water or penis to interfere with the pressure.

Laying down for that long would create a complication for me, since I’m almost always at a desk doing various things.

What about adding salt to the water, have you heard anything about that? I will probably try it soon to see what it’s about. I know people that electrify the water in penis pumps add salt for the purpose of conducting electricity. I assume I’ll get around to testing that eventually unless I make a major break through testing other things first.

Something that has worked well for me is to fill it up in the bathroom.

I use just the tube and suck air/water out for a light pressure (about 0.5cm suction) from the hose and use a rubberband for stopping the pressure release.

Then I press the tube against myself as I walk to the desk and put the tube on to the edge of the desk and wrap a wheat pillow around for heat.

I found this to work really well and the seal is tight enough for not risking any water accident on the floor.

Picture on the setup:

That reminds me of my first attempts at PE. I took a vase and some aquarium tubing in the bath, I couldn’t get a seal since I was just running the tubing through the same hole as my penis.

Have you gotten results that you attribute to this low vacuum pressure water pumping?

How long do you pump this way at a time, and how often do you do it in a week?

I’ve done about three months of vacuum pumping on a daily basis on low pressure 2.5-3hg. And moderate time 10min sets for up to 3 repetitions.

As I got closer to the end of two months I did more single and the occasional multiple set of 20min.

I’ve gained about +0.6cm bone pressed erect length and +0.7cm erect mid girth.

This has mostly been pumping, with 5-10min stretching and the last month occasional clamping.

2/10/19
Measurements:
Erect 15.5cm / 10.7cm

26/12/19
Erect. 16.1cm / 11.4cm.

That’s a really good rate if it can be sustained.

Are you past newbie gains already?

I caution against clamping. It gives the fastest gains of anything I’ve tried initially, but I hit a brick wall with it and ultimately was limited by it in the past. With clamping you need more and more force to stretch out the collagen until it becomes impossible to continue in my experience. A decade later and my penis hasn’t completely recovered. It’s still discolored, still has weaker erections, still has less sensitivity, and still a little too stiff when flaccid.

Thank you.

I could be getting newbie gains. I’ve done this for over a year — but only the last four months really upping the time and focus to the exercises.

Thank you for the caution. Looking back, would you still have clamped if you know what you do now?

No. I wouldn’t have clamped at all, or jelqed, or used an extender.

Light hanging and light pumping seem to be the most effective long term and don’t seem to harm erection strength or sensitivity. The also happen to be the easiest.

Your first post, congrats!

Is it possible you just overdid it?

How did extenders effect you negatively?

I think clamping by definition is over doing it. It produces the fastest results of anything I know of right now, but the cost is too high and it seems to stop growth after a certain point by any method without a long period of recovery.

Extenders causes a significant increase to erect length immediately after stretching the penis to fatigue, but the erect length was shortened for several days after, which didn’t seem conducive to PE. I did set the extender on the highest force setting though. Perhaps if it was worn on the lowest force settings it would be effective. I still wouldn’t use it again though, it’s a hassle to put on, a hassle to wear, and you can’t wear it under your clothes without it being noticed immediately by others. Meanwhile, a light weight hanger can be worn under clothes, it has a set amount of force you won’t be tempted to adjust to the max, and at a low weight you don’t even need to do wrapping. The light weight hanger I use regularly actually makes my bulge less visible by pulling my package downward. I can put it on and forget about it for hours.

Hi Sig,
what hanger’s kind do you use nowadays?
Have you some pictures?
Or instructions to build one?
Tks

Right now I use a U-bolt design. They’re made with an appropriate sized U-bolt and plate and however many nuts or extra weights you want. I use micropore tape over the areas of the hanger that come in contact with the genitals since it seems to prevent abrasion. U-bolts don’t have much use with high weight hanging I think, but they’re excellent for low weight hanging.

I don’t have pictures. I’m one of those people that generally doesn’t take digital pictures.

If you can find a padlock of the appropriate size, that works too, but I think it would be harder to customize the weight.

I think the salt in the water might help soften the water, makes it more slick and nice, easier on the skin. Hard water (chlorinated) dries my skin out and it probably does a number on everyone else. I don’t water pump, but if I did I would for sure use a little salt I bet that feels good. Really soft water with water-based lube is like super slick slippery fun anyway :)