Water pumping
Pumping with warm water in the cylinder makes my sessions much more comfortable and effective, particularly for girth but for length also. The principle is very simple and requires just the cylinder and the plastic tube as some pumps do not work with water and can be ruined by it.
1 - seat on a bidet and fill it with warm water, put the cylinder and the tube in the water to get warm.
2 - use a creamy soap and literally wash penis and balls creating a good foam.
3 - apply as usual the cylinder and start creating a regular air vacuum by sucking the air with mouth.
!!!!!!!! watch your balls or they’ll get sucked in, which most people don’t like !!!!!!!!!!!
4 - once a medium pressure is achieved bend the plastic tube to prevent the air from going back in the cylinder and put it in the warm water
5 - release it and the vacuum pressure will start to absorb the water in the cylinder.
6 - suck again, trying to suck the air and not the water and do it again and again until only water is in the cylinder
7 - create a reasonable pressure, seal the tube by bending it and wrapping the bend with a little elastic and start your session.
This way of pumping gives several advantages:
1 - warmth helps tissue expansion
2 - water, being a more dense fluid than air, distributes the pressure more evenly and comfortably
3 - bruises, fluid buildups and donut effects are greatly reduced
4 - Girth increases much more with long sessions at low pressure in warm water.
I hope it help someone
Perseverance wins