Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Good Vacuum Seal

Good Vacuum Seal

I just bought some pretty big gel toe caps, and used a leather hole puncher to put some holes in it. I use it to protect my glan. It seemed to stay on for a while, until I got to the two hours mark. Then it started slipping off a little, after I pulled on it. I like to pull on it, it gives me a better stretch. Anyways, I was wondering if I could put powder in the cup to avoid slippage?

I’ve read that some guys use talcum powder effectively.


Initial: 7” BPEL; 6” NBPEL; 5.25” - 5.5” MEG

Current: 7-7/8” BPEL; 7-3/8” NBPEL; 8.5” BPFSL; 6.5” MEG; 6”x5” Flaccid.

Goal: Improved/consistent EQ while managing ED. Secondary: maintain current stats.

Thanks a lot 😁. I thought I heard about this technique. I use to put powder on my shaft, when I used to use my strapped extender. I wasn’t out and about yesterday, so I just kept reapplying the seal to it. Yeah, these gel caps have some kind of sticky substance on it. I thought it would help with the grip, but I guess the summertime heat is making it slippery 😄.

I tried the powder, as a test run, with my hanger. It seemed to be working good, until I got to around the last 20 minutes. I think it might’ve been my fault, because I like to twist to each side, to exhaust the suspensory ligaments more. Maybe I’ll just have to see if the LG Hanger glan cover is specifically made for the glans. I was experimenting with silicone toe caps 😄.

Originally Posted by Schlong_7
I tried the powder, as a test run, with my hanger. It seemed to be working good, until I got to around the last 20 minutes. I think it might’ve been my fault, because I like to twist to each side, to exhaust the suspensory ligaments more. Maybe I’ll just have to see if the LG Hanger glan cover is specifically made for the glans. I was experimenting with silicone toe caps 😄.

Yo have an LG Hanger?


Period 1: 06/08/2020 BPFSL: 22cm (8.66") BPEL: 22cm (8.66") EG: 15.8cm (6.25") => 09/07/2020 BPFSL: 23.9cm (9.40")

Period 2: 05/01/2021 BPFSL: 24cm (9.44") BPEL: 22cm (8.66") EG: 15.8cm (6.25") => 07/24/2021 BPFSL: 25.4cm (10.00") BPEL: 23.5cm (9.25")

Goal: 1 Foot x 7.5 Inches (30.48cm x 19.05cm) NBPEL

Btw,

much better beyond talcum powder is this product recommended to me by a stripper girlfriend. I haven’t tried it yet, I will try it once i get a new cup. This product provides a tight non slip grip, is non greasy or sticky.

https://www.ama … /dp/B00KDML8JM/


Period 1: 06/08/2020 BPFSL: 22cm (8.66") BPEL: 22cm (8.66") EG: 15.8cm (6.25") => 09/07/2020 BPFSL: 23.9cm (9.40")

Period 2: 05/01/2021 BPFSL: 24cm (9.44") BPEL: 22cm (8.66") EG: 15.8cm (6.25") => 07/24/2021 BPFSL: 25.4cm (10.00") BPEL: 23.5cm (9.25")

Goal: 1 Foot x 7.5 Inches (30.48cm x 19.05cm) NBPEL

Originally Posted by igigi

Yo have an LG Hanger?

Yes siiiir 😄. I think I’ve been having it since 2015. I’m a hard gainer, and haven’t gain much. I revamped my training after getting gres cacao gres koulev bave beef. It makes me super stretchy. It’s been about 7 months now, and I’ve gained about 3/8" flaccid. When my eq is good, my gain is about 1/4".

Originally Posted by igigi
Btw,

much better beyond talcum powder is this product recommended to me by a stripper girlfriend. I haven’t tried it yet, I will try it once i get a new cup. This product provides a tight non slip grip, is non greasy or sticky.

https://www.ama … /dp/B00KDML8JM/


Thanks so much. I’ll definitely check it out. Can I apply this to my glans cap?

Can’t wait until tomorrow to get this deep cup cylinder from mb. Whenever the tape is outside of the cylinder, the cup slips off. I don’t think a small is too small for me. I was thinking about using my LG hanger instead, but it’s too bulky, and it’s harder to get off.

Should be getting my deep cylinder today, from mb. I hope I can get a better seal from this 😁. I should since it’s a longer length, and this will allow it to go pass the wrapping area. This, there won’t be an unseen gap, where the cylinder and wrapping meets. The cylinder will now go pass the wrapping.

Man, got my medium deep cylinder from mb today, game changer! This thing sucks down on you like a plunger, because the length exceeds the wrapping. Can’t wait until he makes the small. I’m not girthy, so it’ll fit me better than the medium. The medium doesn’t lose its grip though 😁.

Finnuh get some silicone tape, and try it out for a better grip. Might have to punch some holes in it to be sure.

Man, wish I had looked around on Matters of Size more, before I had got my glans cap. They have longer glan caps, so I’m just going to put the cap over the inner cylinder, and wear it like an inner sleeve, under my outer cylinder. I’ll have to punch some holes in it also. Seems like this is the only way to fit in the inner cylinder. I should be able to pull out of the outer cylinder, if I lube up the top of the sleeve. Maybe the Itac2 can be used for this, since it didn’t get a good grip.

Top
Similar Threads 
ThreadStarterForumRepliesLast Post
BathmateHydromax - how to get a good sealAntiMikePenis Pumps111-22-2012 01:09 AM
bathmate users please help (can't get a good seal)stefPenis Pumps402-23-2010 04:49 AM
Vacuum extender vs vacuum hangerdickAugmenterPenis Enlargement Basics101-26-2008 11:06 PM
Any suggestions on a good sealsquashdzlPenis Enlargement Basics306-21-2004 01:32 PM
Help me get a good seal......vegetagdPenis Pumps203-01-2003 11:40 PM

All times are GMT. The time now is 04:21 PM.