Path To A Inch

Be careful for what you wish for, I have the opposite problem when jelqing LoL

Yeah I experienced that today aha, can’t win either way lol

Warmed up in the shower, 5 minutes manual stretching, 90 wet jelqs and 50 kegels. Dick has not been looking as full or plump as it was before, not sure why it went from looking full for a week and now its gone back to normal the past couple of days, measured girth yesterday while erect and it was about 12.2 cm, so ill consider my starting stats 5.9 inches long non bone pressed and 12.2cm girth around the mid shaft

Warmed up in the shower, 6 minutes manual stretching, 100 wet jelqs and 50 kegels, so far I have noticed no changes in EQ.

Measured my mid shaft EG today with a tape measure and its coming up as 4.8 inches, where as a toilet paper roll I have measured at 5.2 inches with the same tape measure I can not fit on my mid shaft no matter what, in this situation do I take the 4.8 or the 5.2?

Cut a short length from the toilet roll, so you have a ring rather than a cylinder and try to fit that on your midshaft. If you are using a tailors tape, you can be pretty sure the measurement is correct. So if you can’t fit the toilet roll ring are you measuring at a lower erection level or tightening the tape too much. The tape shouldn’t dig in, it should be snug.

I will try to cut a ring from it and see if it differs and I have done it at the same EQ, I had both next to me and tested it which was the result I posted above.

Then check how much you’re tightening the tape. If you lay the tape on top of itself and slightly offset, so you can get a reading and then just hold the loose end, what do you see?