A bent cock, worth an extra 1/2 inch!?

One of the main reasons I started PE despite being happy with my size, was the bend in my cock. For some unknown reason, my dick and my glans bend to the left. This occurs about 2/3 to 3/4 of the way up it’s length. Not like how a pipe would bend in a circumference around an angle, but, rather, more like the right hand side has grown more than the left hand side giving it a lopsided look to it.

I was wondering if there was a way of measuring such a piece that could give me the measurement if it were straight, because I would suspect that there could be about as much as 1/2 an inch in there for me. It’s also a mystery as to why the left hand side is somehow stiffer and more taught than the right hand side.

I would mark where the bend starts and measure both the BPEL and BPFSL to that point. Typically BPFSL is longer. Then, I would find the percent change. Finally, I would apply that percent change to the full length BPFSL.

Example
Measure to Curve:
BPFSL = 4”
BPEL = 3.8”
% change = 5% (of BPFSL)

Measure Full Length:
BPFSL = 7”
Estimated Straight BPEL Full = 6.65”

That’s what I would do anyway.

A clear plastic tube just a bit bigger than your diameter might straighten it out for measuring purposes. Get a tight one and lube it inside if you have to. If you can find a clear tube that size, you can mark the graduations right on the side. Then you don’t even need a ruler.

That’s a great idea, thanks.

There is a medical stretcher made for correcting penis curvature,