Major Girth Gain Solution
ULI + Extreme Pumping = ++ Gains in Girth
My story and methods of how I achieved significant gains in length and girth are noted in my other posts.
My starting girth over 30 years ago was about 4.5 inches, I considered it a pencil dick, I.e., is it in yet.
My starting stats were 6.0 BPEL, 4.5 girth
I am currently at 8.5 BPEL, 6.0 glans, 7.0 mid, 8.0+ base.
For the past week I have researched several website forums on PE and have come to a better understanding about how I got to my current stats.
The initial gains in length and girth came from what I have discovered is called “ULI”.
I initially utilized any type of home made adjustable cock strap to trap the blood flow into the penis at the base of the shaft. I then forced, by a milking action below the strap, as much blood as possible into the engorged penis. Eventually the head becomes hard and glossy and the shaft will stretch to its upper limits once the tunica is beyond rock hard.
This exercise causes significant discoloration, and if over done capillary bleeding at the tip of the glans. I can’t remember how many years it’s been since I last saw the natural color of my penis, as well as the true flaccid length.
About 24 months ago I started using an extender for short periods of time and high tension. The BPEL went from 6.75 BPEL to 7.5 BPEL, 5.0 mid girth. All the while I continued my ULI exercises.
Over the past 12 months I began off and on low vacuum pressure pumping, combined with the use of an extender from 6.75 BPEL to 7.5 BPEL, 5.0 glans, 5.5 mid, 6.5 base.
For the next 4 mos I was off and on exercising, resulting in 8.0 BPEL, 5.0 glans, 6.0 mid, 7.0 base.
Essential my largest gains have been achieved in the past month, with a combination of high (over -15 Hg) vacuum pressure for short periods of time followed by extreme ULI exercises, 2X per day, resulting in my current 8.5 BPEL, 6.0 glans, 7.0 mid, 8.0 base.
While pumping, the tip gets to the 8.8+ mark on the tube, and when released goes back to 8.5.
My goal is 10.5 BPEL, 6.5 glans, 7.0 mid, 8.0 base.
Over time I quickly outgrew a 1.75” diam. Cylinder and went to a 12”x2.5”.
I will next be using a 2.25” diam. Cylinder to prevent any addition girth at the base and mid shaft, while allowing for elongation and glans expansion.