Painful pinching at top of corona when hanging

Hi,

I built a hanging device - a slight variation on the captain’s wench - and I want to start using it. But it seems that no matter how I adjust the position of the clamp, it still ends up pinching painfully against the top of the corona when I try to start the hanging session, making it impossible to continue for more than minute.

Also, the pressure sometimes causes the top of the corona to “fold” inward, creating even more pinching. I’ve seen the same thing with extenders.

Any advice? Maybe I’m using a little too much weight?

Thanks!

How long have you been hanging? or trying to? How much weight are you using? What kind of wrap are you using?

I only started hanging after 4 months of daily manual PE, particularly stretching.
Conditioning of the penis is essential before you can attempt hanging, which is an advanced type of PE.

It took some practise to get the wrapping nice and tight so that when I attach the hanging device, that it does not slip down and stress the glans at all.

Even now after 10 months of hanging daily, if I’m sloppy with the wrapping of my cock, the slippage can cause pressure on the glans, which you don’t want. I then rewrap more carefully and tightly.

I wrap as high as possible on the base of my cock and before I attach the hanging device I also pull free some scrotum which will be pinched under the wrapping due to wrapping so close to the base of my cock.

If my wrapping is sloppy and too close to the glans it does not work.

The wrap is a micropore tape. I’d been hanging up to 10-15 lbs with a vacuum hanger for the last few months, until I got sick of replacing broken silicone sleeves. I’d been starting this new system at 10-15lbs.