Buying an Hose Clamp. Need Assistance with Sizing.

http://www.clas ohlson.se/Produ … spx?id=73313801

My MEG is about ~ 4.3" And base at about 4.5"

Erect Diameter (Middle of the penis) =11/3.14=3.5 cm

For growing purposes: Would it be wise to choose the 30-9537 Which has an Diameter range from 3 - 4.5 cm?

Is -0.5 cm(in diameter) enough for clamping?

Bad idea.

You need to be able to get the damn thing off in a hurry if need be. Won’t it be great to try to unscrew it under stress, slip with the screwdriver and cut a nice deep gash in your dick, bleed all over the fucking place and get everything so slippery with blood that you can’t unscrew the clamp at all?

Please, get a cable clamp.

Or take large diameter perlon rope (repsnöre, go to a camping store), like 6 mm or so and use a wooden handle (pencil, cut-off cooking utensil) to twist the rope tight over your padding that you’ve wrapped around the shaft. Easy to tighten, easy to get off.

Hey mgus and in my case that are in a different country and don’t have cable clamp accessible, there are any thing that substitutes?

If you are going to use a hose clamp, use one with a built in key. And keep pliers handy.

http://www.dire ctindustry.com/ … 764-390225.html

Or do as I wrote in my previous post.

Thanks for the input bro ;)

C.phantasy,

Knyt en rund slinga av repsnöre, stoppa igenom det avsågade slevskaftet och vrid runt det, så snurras repet runt sig själv och dras åt. Så gjorde man förr i tiden för när det inte fanns spaklyftare, och även ibland när man garrotterar. Nå, då blir slingan mindre och mindre gradvis och så länge du håller fast slevskaftet så är det spänt. Släpper du så snurrar det upp sig själv. Tar du ett längre slevskaft så kan du säkert lägga ena änden mot magen eller höften så att den hålls kvar utan att du måste hålla i med handen.

(just explaining how to take a sling and a wooden handle and twist it so that the sling tightens)

You can also glue a dime or another thin piece of metal into the slot that allows it to function as a key. I used Crazy Glue for mine. The pliers are still a good idea, though; the dime is fairly small.

I use a hose clamp as shown in the opening post’s link. With a screwdriver, actually. I’m just careful. You can use a small spanner too.

Funny thing, I bought it at a hardware store and there was a lady running it. And she asked me what size I wanted. And I wasn’t quite sure either. She started by showing me the small garden hose variety and the conversation went something like “umm.. No bigger.” “these?” “err.. No bigger.” “oh. How about these then?” “no really. Bigger.” “wtf?? These then?” etc. It was funny.

Anyway. If you are going to use hose clamps, the biggest you can find should probably work. You can tighten them at will.

Carpenter aye?

Tack för tipset ;)

Edit:Now when I think about it,it is really a superb idea! Perhaps even better than a Cable clamp…

Thanks! There not any hose clamp made of plastic?

I searched for cable clamps in Europe and found many listings, this is one

http://www.alib aba.com/product … able_Clamp.html

Thank dino, I think manual PE don’t work anymore for me, want to try something different

That’s all well and good if you want to use a new clamp every day for the next 13 years!

Once upon a time, yes.

Report back with your experiments.