Clamp and BallZinger results

I’ve been clamping for about 2 or 3 months, and I’ve seen about 1/4” gain. I’m a pretty slow girth gainer, but this is a lot faster than I ever gained before. I’ve also in the last 2 months seen a 3/8” length gain, but I haven’t done any stretches. I can only attribute it to the clamps. Also, yes, I love the BZ/ROP/whatever. The ol balls are bigger than they used to be! Fun fun!

For my clamp routine, I do it on M W F, and I do a half hour session. After that I keep it loosely clamped around the whole package for the rest of the day. It helps keep the post-workout pump and a nice bulge haha. This summer I won’t have a lot of time to do PE, but I’ll keep doing the all day clamping. When I start the fall semester though I’m probably going to start doing 2 or 3 shorter clamp session if I can.

Hey 9 I didn’t know you also gained 3/8 inch length from the clamps! Good to hear!

Yeah man. That was about a month ago when I reported that gain, but since then I had to take a 2 week break, so I lost a bit of the length gain since it wasn’t cemented, but the girth gain stayed (thankfully). I’m now at 7 3/4” x 5 1/4 I believe.

Are you guys clamping the shaft only or behind the testicles to get in further?

Scott

Me, shaft only.

I have seen a small increase in permanent gains, but what really is exciting (excuse the pun) is the increase in temporary girth when I clamp.

Ive gone from 5.2 to almost 5.6 inches in a matter of three weeks.

I only clamp after a hanging session and then only two to three times a week for between 10 and 20 minutes, depending on time available.

Id expect to begin cementing some of those temporary gains in the near future as I step up my clamping routine. What I love about clamping in because it stretches in all directions, I don’t think that it is detrimental to length. I certainly have not had a slowing in rate of length gains. If anything, my rate of length gains has increased after starting to clamp. I really is too early for me to say with any certainty at this stage though.

First off let me say Hughjorgan9 that I agree with you all the way. Even before reading you letter to Kerry I did not think that he would be as good as Bush. Bush sent us over there for a reason. I dont care what it was for because there is so much that goes on with the world that we dont know (but pretend we do) what to call bad or good. We did our time and that is all that any fellow american can expect from us as our job, as our duty.

As far as clamping… I use the white clamp but I am having some trouble. Is there a certain position to get the best clamp? ie do the jaws have to close in from the sides or the top? What is the best approach?

I will be watching this thread closely. I’ve been practicing the clamping style described here for 7 months with only 3/16” gain to show for it. Be interested to hear if it’s actually working for others.

Any updates?

What sort of size increases has anyone had in their balls from the ballzinger? I’m interested in making one as I’ve heard it’s good for increasing ball size and giving you Peter North loads, but does this actually happen? Has anyone taken any measurements of there balls before using the ballzinger and a while after starting it?

Also, are there any bad side effects of the ballzinger?

Thanks guys!

I’ve noticed people recommending clamp size based on its colour. You should know that they are not colour coded for size. The pack I got has both red and white for small and blue for medium. That’s different to the two other references in this thread.

Shiver,
But the medium clamps are usually red. I don’t remember what the colors were at Walmart in the multi packs(in the extension cord aisle for those looking), but at Ace Hardware I have only seen red ones. Of course it doesn’t matter what color you use! :D

I’ve been back clamping for a few weeks, and am in the process of making a ball zinger. Only thing I’m missing is the zinc rod, but it’s on the way.

I’m surprised how much people are selling these for since my total cost will be under $10, and it will only take minutes to make once I have the zinc rod.

>I’m surprised how much people are selling these for

So am I, considering mine cost $.02. I had no results, as expected. Read the thread for voltage and current readings - same or better than ~ Tom Hubbard’s ball zinger design being hyped and sold lately by several hucksters and their friends. They are pocketing $50 or so for each sale of a few bucks worth of metal and latex. Quite the racket.

$.99 spent on a cable clamp is a better PE investment, IMO, and I’m not even fond of using cable clamps for Ulis. Better off buying a $.39 hose clamp, some leather or tubing, and using a real Uli thing. Forget about the magical nut electro-zapper. If you insist on trying one please don’t be conned out of $60. There are cheaper alternatives.

I have two medium sized cable clamps. One is orange and the other red, so color doesn’t matter.

Agreed, I just had visions of people using the small ones thinking they were medium based on the colour then wondering why they were feeling pain :) (or using the large ones and feeling wholely inadequate!).

I agree, that’s why a couple of weeks ago they were free! I can’t say I’ve noticed much with mine except that it keeps popping off and that with the current weather it’s very sweaty. The first week I tried it I thought I had maybe 20% bigger nuts then had to stop due to what was either a rash or chaffing on the copper side (I had 12mm copper back then before Trigger kindly donated some). Since then I’ve noticed that my nuts vary in perceived size enoormouly throughout the week, and I’m beginning to wonder if I really know how to measure them.

I’ll see the month out with the zinger since I asked the other 11 guys in the experiment to do so, but so far I don’t have high hopes for it. I am of course expecting 2 or 3 of those guys to find great benefit with it, and that it will prove to be a very individual thing.

So you’d definitely say the zinger can increase ball size?