Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Clamp and BallZinger results

1234

No I wouldn’t definately say that. In the previous post “I thought I had maybe” 20%. It was a subjective obervation. I then went on to say “Since then I’ve noticed that my nuts vary in perceived size enoormouly [meaning enormously] throughout the week, and I’m beginning to wonder if I really know how to measure them”.

Regards

Shiver

Rifor,
I measured today and mine are about 2.125” long and 1.25” wide each. I have measured them in the past and they have been slightly larger, as well as noticably smaller.

I don’t have a zinger to wear yet, but I’ll definitely keep this as a reference measurment.

The only negative I’ve heard is the skin reaction to the copper that Shiver mentioned. Maybe this can be alleviated by switching the side the copper is on, or by taking a few days off when needed.

Ah, I get you now Shiver. The large variation is up as well as down.

I’ll wait until you and the other 11 have used the zinger for the month, then see if any of you have had an increase in ball size with it so I know whether its worth me making one.

The thing is, the people over at PEForum claim it does increase ball size, but I’ve not found much info on the ballzinger’s effect on ball size hereat Thunder’s. :confused:


Start: 22 Mar 04: 6.5" BPEL x 4.6" EG & 6" head. As at: 1 Jan 05: 7.5" BPEL x 4.8-4.9" EG & 6.3" head.

Re-re-start!: 6 Feb 17: 6.9" BPEL x 4.9" EG & 5.5" head. As of: 23 Feb 17: 7.0" BPEL x 5.0" EG & 6.0" head.

Ideal: ASAP: 8+" BPEL x 5.5+" EG & 6.5+" head But will continue if the going is good!!

Originally Posted by MDC
The only negative I’ve heard is the skin reaction to the copper that Shiver mentioned. Maybe this can be alleviated by switching the side the copper is on, or by taking a few days off when needed.

I couldn’t say for certain if it was a reaction that I had. The skin had red marks all over it. It wasn’t sore at that point but decided it would be better to back off. The most likely cause was that the copper was 12mm diameter, so I had to put it over the PVC. I didn’t pay much attention to sanding it smooth, and although it didn’t feel rough to the touch it may have had an edge on it that was too much for the softer skin around my sack. Alternatively it could have been trapping the skin between the tube and PVC pipe. The marks were too small to tell if they were spots or actual cuts.

Once I switched to the micro bore copper which has the ends inside the tube I never had any issue again. I’m pretty sure the grade of copper was the same for both, since its all for household plumbing.

Rifor, I have a significant increase in the testicle/scrotum size when I do two things. Clamp and jelq and immediately put on the BZ, making it a little tighter than usual. I do this right before bedtime. When in bed, watch Cinemax’s low grade “mature” movies to get rock hard for a good 15 minutes. I seem to stay hard for quite some time and even wake up in the middle of the night several times from throbbing erections. I wake up with an erection and my testicles and scrotum are about 20-30% larger (my guesstimate). Once I take off the BZ, in a few hours they return to normal size. Not sure if it is fluid buildup or temporary gain in size, or if I wore it 24/7 if they would keep getting bigger, or if there are any permanent results.

HJ

I got my zinc rod yesterday and made my BZ. I mistakenly ordered the 1/2” rod, but it seems like it will still work fine. I wore it for several hours last night, and my flaccid size never went down to where it usually does. I forgot to put it on before going to sleep, but I’ll be sure to wear it all night most of the time.

Top
1234

All times are GMT. The time now is 02:22 AM.