I wasn’t going to respond to any of this, but I feel a bit of an obligation to members here who may very well injure themselves with improper clamping, or Dangerous Clamping Technique, due to suggestions on this thread. I get a lot of PMs asking for clamping advice. The easy out might be to just start telling everyone, Don’t Do It.
We seem to have a new generation of clampers now who have no fear, or no respect for what some of the old-timers here have learned by trial and era and medical bills. That’s fine. You guys do what you want. Four or five years down the road when your dicks no longer work, you may remember some of these warnings.
It is very easy for someone who has only been clamping for a short time to say, that they have pushed clamping to the limits and have had no problems. Truth is, they haven’t been doing this long enough to have had any problems, yet. I can assure you, that if you guys keep on clamping mid and upper shaft with multiple clamps for long sets, eventually you will pay the price.
The reason multiple clamps are dangerous is not because you are clamping too tight, (You have to clamp tight) but because by stacking these things you end up clamping at a spot where injury is much more likely to occur, than at the tougher base shaft. Three or even four clamps won’t clamp you any tighter than one single clamp if you use the right amount of wrap, it just feels tighter because you are pushing all that blood up the shaft, which will encourage the baseball bat shape.
I recommend the use of a single clamp at the base because my urologist has assured me that this is the safest way to do it, and probably the most effective. Actually, her exact words were, “There really is no safe way to do this, but if you must clamp, do it here.”
I take heed to the good doctor’s words, some of them anyway, but I also know what I’ve learned from over seven years of pushing these girth routines to the limit, and that is, the less shaft constricted by the clamp the better the results.
The idea is not to cover more surface area of the shaft, but less. In fact, the perfect clamp for PE would be a CableClamp that was half the width of the medium clamp, or less. A Cable Clamp that is the width of a cock ring would be most effective.
I’ve been working on a modification to the medium sized clamp for just this purpose.
I’ve taken a dermal and cut away the inside lip of the clamp so the band of plastic that actually chokes off the engorgement is very narrow. I haven’t measured it yet, but I would estimate the inside lip is less than 1/8th inch wide. I’ve left the outside of the clamp in tact for strength.
This alteration of the clamp may make it too weak, or cause it to break easy, so I don’t suggest it to members who are having trouble finding the clamps. If you want to try this you may want to practice on a broken clamp first.
But these cuts are pretty easy to make using the thin cutting wheel of a dermal. The way the clamps are made, the inside cuts can be made without weakening the outside, which is where most of the stress occurs when they lock down.
If you try this, wear a glove, or put the clamp in a table vice to make the cuts.
I’ll post back here in a few days after I see how the narrow clamp holds up. If it’s a success, I’ll post some pics on where to make the cuts. However, it‘s pretty obvious just by looking at the clamp when it is closed all the way. Just cut away the inside part that touches your dick (Or Wrap) and leave the outside lip as it is.