Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Cock Coil ADS

Gotta confess, I’m having trouble with my CC. I did a workman-like job on it, satisfied with the finish; but the 1/4” lead is stiff, & it’s tough to get it snugged up behind the glans in a way that 1) doesn’t hurt like hell, & 2) won’t slip off & fall on the sidewalk! I even pared back the shrink-tube 3” & hammered the end to a nice taper for 2”, then covered it with a length of shrink tube. But keeping it in place while moving around is still a problem unless I use a “safety line” to catch it when/if it slips off!

Ideas, anyone?


Stone phallus totem in Formosa Aboriginal Cultural Village

First thing I’d recommend is positioning the CC toward the base for comfort. Once you’ve established a comfortable technique you can try moving it closer to the glans if you want, but it isn’t necessary. Wearing it near the base my flaccid will hang about 1” or 1.5” longer than normal. I would even wear a longer coil, or a second coil to reach further toward the glans - rather than wearing a single coil near the glans.

Second thing is it shouldn’t be slipping or moving at all. Just coil it snug. Maybe retighten once. You don’t need to tighten the end near the glans more than the rest - just make sure it’s hugging the shaft evenly through the whole coil, gripping a little bit everywhere. It should be rather comfortable.

In terms of doing very athletic activities, that’s not quite what it’s for. It can be done, but you have to tighten it a little more than is comfortable for long periods of time. If you’re doing running for example, you might have to tighten it up a bit before the run, and then loosen it a bit afterward. And then you’ll have a pound of led thwacking you in the legs and balls while you run. In general, I would recommend just not wearing it while being extremely active.

Xeno once said of the cock coil, a little bit goes a long way, a lot doesn’t go much further. So if you can find a couple hours per day to wear it when you know you won’t have to move around more than walking, that’s enough.


Before 5.5" x 4.1" ///////// Now 7.4" x 4.9"

Thanks for advice, BD. This morning I took more time putting it on, twisted it tighter all the way down the shaft like you suggested. Then wore it while I mowed the grass (walk-behind mower) & it did seem better. Originally I had been expecting the glans to bear the entire weight, so I concentrated on making it very tight behind the glans; but now I think I have the right technique, with the full-length twist. Thanks again!


Stone phallus totem in Formosa Aboriginal Cultural Village

Mowed with the CC again, & it’s a good thing I had a safety line on it because it slipped off again. For me, the CC is for standing around without much activity at all! I’ll try an even tighter twist.


Stone phallus totem in Formosa Aboriginal Cultural Village

Originally Posted by Trekker
Gotta confess, I’m having trouble with my CC. I did a workman-like job on it, satisfied with the finish; but the 1/4” lead is stiff, & it’s tough to get it snugged up behind the glans in a way that 1) doesn’t hurt like hell, & 2) won’t slip off & fall on the sidewalk! I even pared back the shrink-tube 3” & hammered the end to a nice taper for 2”, then covered it with a length of shrink tube. But keeping it in place while moving around is still a problem unless I use a “safety line” to catch it when/if it slips off!

Ideas, anyone?

I have better success when I heat my CC up with a Hair Dryer, it makes the lead more malleable and you can wrap it around your shaft easier.
I started with one CC, but I am now using 2 CC, for both a stretch and hanging.
I wear it for about 1-1 1/2 hours with a hour off in between.
Everyone is different, I find this works for me.

Originally Posted by JWallJ23
I have better success when I heat my CC up with a Hair Dryer, it makes the lead more malleable and you can wrap it around your shaft easier.
I started with one CC, but I am now using 2 CC, for both a stretch and hanging.
I wear it for about 1-1 1/2 hours with a hour off in between.
Everyone is different, I find this works for me.

I have not used my CC for a few weeks now because of my life and circumstances.
After reading the post and replying .
I decided to put them back on today as I can do it again.
I do not know if this good or not, I wish I had keep better records and stats when I began for stretched and non stretched flaccid penis measures.
Here are my measurements as such with CC on:
Non bone pressed flaccid Penis-7 1/2 inches
Bone pressed flaccid Penis-8 1/2 inches

Originally Posted by JWallJ23

I have better success when I heat my CC up with a Hair Dryer, it makes the lead more malleable and you can wrap it around your shaft easier.

I started with one CC, but I am now using 2 CC, for both a stretch and hanging.

I wear it for about 1-1 1/2 hours with a hour off in between.

Everyone is different, I find this works for me.

JWall, I like your idea to heat the CC with a hair dryer; I’m gonna try it & see if making it more malleable solves the problem. I’ll test it in the relative safety of the back yard next time I mow; if I can keep it in place, problem solved! I like the CC as an alternative concealable stretcher — as long as it doesn’t fall off onto the sidewalk!


Stone phallus totem in Formosa Aboriginal Cultural Village

Ribbed for his pleasure

I recently found out a new application for the cock coil. Set to the right circumference, add some water based lube, and the cock coil makes a great glans massager. Clean up is easy as rinsing it in the sink. Every time I’ve done this the erection won’t go down afterward. Not sure that it has any benefit to gaining, but it’s fun! Wouldn’t want to do it for a day or two afterward though. Those coils are unforgiving. There’s probably a Darwin award waiting to happen somewhere in this for masturbating with a lead coil. Maybe I’ll have to make one of these out of copper. Definitely make sure the ends of the shrink wrapped coil are plugged for this.


Before 5.5" x 4.1" ///////// Now 7.4" x 4.9"

Hey Cock Coilers,

This idea has popped up a few times in my TP exploring the past couple weeks. (Thanks for keeping this thread active BeardedDragon.) I’m in the research stage of exploring ADS options. How are you guys feeling about the CC relative to other ADS options? I’ve read several (not all) pages of this thread, and people seem to really like it. I just don’t know how it compares with other things folks have tried.

Also, if you have other ADS recommendations but don’t want to derail this thread, I’d welcome your PM.

Thanks for any feedback. Here’s to everyone’s gains in 2019… EZ


BEGINNING : BPEL 6", MSEG 4.6", NBPFL-Hang ~4" x 4", BPFSL 5.8"

1 YEAR : coming up! BPEL ", MSEG ", NBPFL-Hang " x ", BPFSL "

MY PROGRESS: Affirming My Cock: EZduzzit's PE Journey

I’ve been reading and exploring BD’s and Xenos ideas (posts).Thanks BD for all of your ideas and explanation , very informative. I’m glad everything has started to resurface. Recently bought and made the CC and would have to say it does a fantastic job of stretching and elongating. Tension is the key as to comfort.

Any intact (uncut) guys out there using a Cock Coil? If so are you retracting your foreskin?

I have a D22 Stealth Corkscrew, which weighs 500 grams. Nice piece, see my review under reviews.

I have tried to use both my Innerware and Corkscrew retracted, and I am not sure I am interested in becoming fully accustomed to that.

I have ordered a larger Innerware and another Corkscrew from Stealth, but can’t keep the coil off my dick..

I am getting closer to the tension required to carry the thing without turning the exposed skin and glans purple, however still seem to be getting Lymph fluid build up on the end of the foreskin.

Is there a manic tension that I may find that will keep this from happening?

Should the glans be full?

Looking for suggestions from intact guys on how they hang their Coils/Cockscrews.

I seem to be getting the hang of this, that is if I can keep it from becoming a clamp and getting a hard on.. See my pics and latest configuration in my progress report.

Looking forward to building my Cock Coil.

Some parts have arrived and some are in the mail.

Gotta read the rest of the advice on this thread.

Freaking brilliant idea (except for the lead part but whatever, still brilliant, simple and sleek)


Starting (07/15/20): BPEL 6.5” BPFSL 6.5” MSEG 4.75” BEG 4.75” BPFL 4.5”

Current (10/27/20): BPEL 7.0” BPFSL 7.5” MSEG 5.0”+ BEG 5.25” BPFL 5.25-5.75”

Goal: BPEL 7.5” MSEG 5.5” BEG 6.0” BPFL 6.5”

I logged 5.5 hours in the cock coill, my first run.

It felt a bit awkward for the first 15 mins. However, I was out and about with my family, shopping and what not. It felt as if it wasn’t there. At times I bad a bit of a pleasant tingling sensation as if flaccid gains were under way.

It felt so comfortable that I had to check to make sure it was still on. After lifting some boxes, it did slip a bit, however, it didn’t feel like it would come off due to the multiple cohesion points. If these were shaft collars or golf weights, I suppose a slip could result in an easier loss and completely slip of.

I had a slight pinch from the Velcro of my ace bandage wrap. Looking forward to the arrival of my HTWs. If they are the right ones, I am going to buy an ish load of them now as I am committed to PE for the long haul and these are one of the items, which if discontinued, can through a real hamper in the mix.

I am going to apply the epoxy seal to the ends of my cock coil right now and then hit the hot tub. I could have easily worn it for a longer duration if I wanted to. I feel like I could do play golf with it on. I feel that if I had to defend myself while wearing the CC it would not be a big deal. However, I feel like I could get seriously hurt defending myself while wearing a traction extender. This is something of concern with how things are on the streets right now.

Looking forward to continued use of my cock coil!!!! Loving It!!!


Starting (07/15/20): BPEL 6.5” BPFSL 6.5” MSEG 4.75” BEG 4.75” BPFL 4.5”

Current (10/27/20): BPEL 7.0” BPFSL 7.5” MSEG 5.0”+ BEG 5.25” BPFL 5.25-5.75”

Goal: BPEL 7.5” MSEG 5.5” BEG 6.0” BPFL 6.5”

Congrats on finding a great ADS. I’ve been “logging” about 5 hours a day lately as well.


Before 5.5" x 4.1" ///////// Now 7.4" x 4.9"

Top

All times are GMT. The time now is 03:27 AM.