Cock Ring Question

I just bought a set of 3 Cock Rings online. I’ve never used these before. The largest one is REALLY small, like 3/4” width and it stretches, but is extremely tight. I am average width mind you.

I could barely get this thing on. I had to stretch it so much I thought it was going to rip and it is so freakin’ tight I had to pull it off immediately. Since I’ve never used them before I don’t know how they supposed to fit, but I can’t imagine this is right.

Anyone out there use these? How tight do they supposed to fit? Can you injure yourself if it’s too tight?

Thanks.

Yes you can injure yourself if they’re too tight, I have a 1.5” inner diameter metal ring but I can’t wear it at full blown erection cos it cuts the veins off, heaven knows what a 3/4” is doing! Just ordered myself a 2” Cyberskin job. Get rid and get yourself some sturdier material..

Best of luck..

Heheh, I cut a 1.5” diameter PVC pipe and filed down the edges, makes a perfect cock ring for my little guy, first time I ever “wore” one, and I imagine that cock rings are supposed to stretch a bit, so I suppose I shouldn’t wear it, but man was my cock exhausted afterward, had a great erection, almost jacked off but I was afraid I might hurt myself. :)

(for the record I’m 4.5” circumference girth and the inside of the PVC pipe is, okay, just measured, 1.25” diameter, times 3.141, equals 3.92”, ahh, no wonder it swelled, half inch smaller!)

Definitely getting a cock ring though, what size would you suggest, and am I right that a PVC pipe is too dangerous? (No stretching room.) TIA (good topic btw!)

Though I’ve never used a cock ring, ideally they’re not supposed to stretch. Some of the ring vets here could give a better description than I could. But basically, you want to take a measure at full blown erection, base girth of course, because that’s where the ring will be. Then, I think you’re supposed to order than ring about 1/8” less than your base girth - and slip the (metal) ring on before you’re fully erect.

That’s how I understand them to work.

I went to a local garden/hardware store a bought a variety of 0-rings. Very cheap ($.50).

I’m roughly 5” mid shaft, and a little less at the base but with some lubricant the o-ring

Slides on fairly easy. And for an excllent lube try Pjur, Eros bodyglide.

Hey guys please make sure you get the correct size cock rings, so you don’t have to go through what I went through. I bought the wrong size and was mid way through a sex session with the old lady and lost felling to my little buddy. It swelled so bad, it took me almost an hour to get it off. I used cold water, soap, baby oil and anything else I could find to make it slip off. It scared the crap out of me. It took about a week before all of the feeling in my dick came back. Just be carefull. If it’s too small, buy another one. They’re cheap! definately not worth a permanant injury.