Penimaster of similar device users.

For those of you that use a Penimaster or something similar which way do you wear it, up or down?

I ask because I have noticed a lot of difference depending on how I wear it.
If I wear it down the front of the penis is stretched and I can feel a few previous thrombosed veins getting tight. So I decided to wear it up and this takes a lot of the stress off of the front of the penis and those veins. The bottom of the penis though feels nice and stretched.

I have an upward curve which I like but I wonder if it will produce more of a curve wearing it this way? (I don’t want anymore of a curve).

I have also noticed that the penis is stretched when standing but when I sit down (which is most of the time) the stress is taken off. Do any of you notice the same?

bluenun,

I find it works the other way I feel more stretch (and less comfortable) when I wear it down. And things tend to pop out more that way, but that could be leg movement.

But it may be because I don’t have a curve, so that could be the answer

I’ve worn a stretcher down as well as up. When you wear it down you target your ligs and when you wear it up you target your tunica. When you wear it down there’s more skinstretch going on at the top of your shaft and also your veins might get some tension. Wearing it up solves this but you can also attach your stretcher higher up your shaft if that is possible. If you’re cut you can use it to your advantage by letting your foreskin regrow.

You should check your LOT to see if it’s high because then you will benefit more from wearing it down.

I don’t see how wearing the stretcher up could give you a curve. Your entire shaft is stretched straight. I think there is a slight chance of raising your erection angle but that’s about it.

Petitfaun, thanks for your experience. It is interesting that it affects you the other way around. Like you say I wonder if it is due to my upward curve.

Piet, my LOT appears to be around 7 or 7:30 so I guess wearing it up is not a bad idea anyway.

I have had some thrombosed veins in the past on the top of my penis from hanging BTC and SD. It appears that my foreskin does not like to be stretched so I am cautious of overstretching my penis/skin.

Wearing the Penimaster up seems to take a lot of stress off the top of my penis.
The reason I asked if it could exaggerate my upward curve is because more of the stress seems to be concentrated on the underneath of my Penis if you know what I mean.

I notice the opposite. when I stand I can stretch my penis more with my device, but when I sit down my dick gets pulled into my body a little bit. Sometimes I have to reset the stretch level.

Bluenun, you could be right the bottom of your tunica is being stretched more, however because you don’t feel your skin being stretched ontop it doesn’t mean the top of your tunica isn’t being stretched about as much as the bottom.

Interesting thread, I wanted to start a similar one. ;)

I assume that most of them PM users have worn it down, not up. As I wear it up because it’s more comfortable and because of my low LOT, I’m interested in knowing how many PM users have gained by wearing it up.

As we know it’s easier to gain from ligs than from tunica stretching, (assuming you have a high lot of course) and I remember that I read in the user manual it would be better wearing it down, but for reasons of comfort I think.

Kinxxx,

I have worn mine exclusively in the up position for the last 3 months or so. I also pump so it’s a combination of these two mechanisms that I rely on. I have realized decent gains from the combination of stretchin g& pumping.

Regards,

MrTiPS

THX for your reply.

I’ve worn it mostly up.

Started in June 2004 at 6.25 BPEL
Now: 7 BPEL

Ok Rambone

I need more motivation and determination to wear it 6 hours a day damn!!!

I dont think however you wear a traction device will matter. If you have an upward curve, the CC is shorter on the top. A traction device should put more stress on this area first while it elongates it. Thus making the curve lessen over time. I dont see the ligs being involved on a traction device.