Trying to get a.. head

My situation:

I have several inches of usable girth in/around the 5.5 inches margin. However my unit disappointingly tapers off so that the corona of my glans is a rather slim 4.3 inches.

Does anyone else have this? Am I alone in my suffering?

You can try this cylinder Buy this GlansXpands Pro Maximizer at Pumptoys.Com

It’s specifically for the glands increase, if you don’t want any more length or girth gain, make sure to buy the exact fit for your penis so that only your glans will expand.

Remember to use a lot of water based lube and heat throughout the entire process, try 3 sets of 15 minutes at 4hg and maybe increasing to 5hg in the last set.

After you get conditioned you can try increasing length of each set and the number of sets.

I started at 6.5 base, 6 mid and 5.5 head girths. By simply jelqing and hanging I got to 7 base, 6.125 mid and 6 head.

All of my girth came from stretching, hanging and manual stretching.

My brief clamping career killed my E.Q. And I didn’t like that.

I’ve incorporated 2 things for this so far. Just the basic wet jelq from the base to the head but I stop at the head and hold for about 5-7 seconds after each rep at the base of the head and do this 50 times. Also, clamping has worked wonders. Clamp the base and then clamp just below the head and hold for about ten minutes. I’m just starting pumping this week as well.

Ulis. Started with about a 5.5” circumference around my coronal ridge; now it’s 7”. Other methods have contributed too, but Ulis have contributed most.

To a woman, a big glans is…memorable :)

xeno

Kegel and inmediatly make an ok grip near to your body (an ULI).
Hold on a few seconds.
Release and repeat.

You can see how your glans inflates every time you kegel, pretty funny to watch.

Now, if I hear cackling from behind a bathroom door, I’ll know why.

Head girth tricks I’ve used…

ULI #3. Especially if you relax the grip a touch to kegels more blood in as you move upward.

Pumping with a silicone sleeve. It adds stress on the head.

Jelqing or ULI#3 with a rubber band or condom base ring beneath the glans. This trick isn’t comfortable but does work and requires dry hands to get this condom ring off. It constricts blood flow so forcing it engorges the glans longer and to a greater potential degree. This was my first glans technique. Only do it for 5-10 mins at a time then take a break.

Sadsak Slinky works well too.

Why not clamp just under the head?

Sensitivity issues. Girth and wrapping are not as simple the closer to the tip of the shaft you get.

Also, if you’re a pumper, use a sleeve and cut it to fit just the shaft. The cylinder you’re using should still work for this, you shouldn’t have to resize it (I didn’t when I started with a sleeve).

So when cutting the sleeve to fit your shaft leave an inch or so for the base to seal the cylinder and leave some room just under the head, maybe 3/4”. When you pump, the base will inflate enough to seal and the compression on the shaft will minimize the effect of the pressure (relieving edema concerns greatly) and the pressure will focus much more on the head. This will cause some pretty amazing expansion even at pressures of 2-5HG. It’s a side effect I’ve observed using a pumping silicone sleeve here recently.

That’s a great idea for circumventing otherwise very expensive glans specific pumps. Nice one.

I used to feel how you felt. Glans cylinders are so damn finicky to size that they don’t feel worth the risk in my opinion though. So, that’s why I made sure to list that you should be able to use your regular cylinder. I know I do.

That’s awesome I’m going to add it to the list.