ADS

I have been just doing “recreational” pumping (just getting it big before me and the wife have sex) 1-3x/week for the last 12yrs. I saw some gains in that time (5/8 inches in length), but nothing significant, but I also knew that I wasn’t really serious.

Starting 2 weeks ago I have been doing ADS at work, stealth, under my baggy scrubs. I have been using a sock, clamp, Velcro leg strap, rope, thick rubber band. I did it for 32 hrs. The first week and 40 hrs. The 2ND week. I also started jelqing 400 jelqs/day starting week 2. I try to have the leg strap low enough so that the pull is moderately strong (I can definitely feel it tug on my dick when I am standing which is often as I am an Registered Nurse. When I sit down to chart at the computer I move the strap so I fee a light-moderate tug still while I am sitting. I take it off every 2hrs when I use the bathroom.

Question 1. Where can I BUY a better ADS than my “homemade” one? I am happy with what I made so far. It does the job, but I want to use something other than a clamp to keep it on.

Question 2. How many hours until I start seeing actual Erect and Flaccid gains? After 500 hours, how much gains should I see?
I am currently 7 1/4 BPEL. I need to do flaccid bone pressed and non-bone pressed measurements too.

Question 3: How much tension is “enough”. Is more better? Like is 1lb or 2lbs enough?

Question 4. Can I still do my “recreational” pumping before sex?

So far after 2 weeks, I do notice it hanging better flaccid, but have not really measured that. BPEL is still 7 1/4. I also have some rock hard erections in the morning (more than before).

Thanks
Thickone1740

Howdy, I’m new here but a veteran PE guy. The method that seemed to work for me was buying something called the Circle Device from Dfrance. Google it. Its expensive, made from pewter, but, it was what got me the gains mostly in length. I bought the 2 pounder (32 ounces) and then attached adhesive car wheel weights until it weighed a total of 4 pounds. I wore it every day for usually 8 hours for several weeks and gained over an inch in a short time. The rod stretchers you see online have approximately 3.5 to 4.5 pounds of gram resistance, so wearing an ADS that weighs 4+ pounds will get you the fastest gains in the shortest time. Just be careful to watch for coldness and tingling.. Both are bad signs.

This is a good setup for a ADS, and what I am using

That looks like a good setup and ever since it came out I’ve been tempted to try it. Hate to have that slingshot tube give out though.ouch! Looks very tempting to try.. How comfortable is it?

That circle device looks kind of cool. It’s it lead?

Its made from pure pewter, which is non toxic and doesn’t grab on the skin. Its cool if you get the measurements right. Carefully measure the circumference of your unit for a proper fit. I have since out grown mine, but, still use it when I can get it to stay on. Wrap below the head if your head is the same thickness as the shaft for a better fit.

The ADS setup I like best is Monkeybar’s Xsleeve. Long silicone sleeve around your penis that holds a cap over your glans. Included in the package is a leg strap and a few s-hooks (autoextender.com). I use a few rubber bands to connect the leg strap to the cap. Recently, I’ve started to cover the silicone sleeve & cap with the ankle portion of an old sock so that it slides more easily against my leg.

I calibrate the weight by adjusting the number of rubber bands. Want more tension? Add another rubber band.

His silicone sleeves come in varying levels of hardness. If you’ve never worn it before, you should get a soft thick sleeve and a medium sleeve. The soft ones tear very easily and don’t last too long. The medium one is far more durable. You wear the soft one to get used to it, and when it breaks, you’re conditioned enough for the medium one.

G’Day, M8ter! Lol
I made my own ADS using the padlock, but that creates a big bulge very low in the pants leg,
I was wondering about something that will stay close to the 7” girth range. I am considering
Using Tungsten Weights, it’s over 50% more dense than lead, but more expense too. I used
Around 1.5 pounds before, and that worked quite well, but I wore it about 10+ hours a day
For over a year. Numbness is a bad sign, but cold never seemed to bother me. Not COLD,
But cool I guess, I could feel the coolness of the glans on my leg. Best thing to do is lift the
Weight up and relieve the pressure for a bit, or sit down. But people tend to notice it down
Near the knee. What I’d do is look them right in the eye, and they could not really look at
My crotch and package too much, because they know that you know they are peeking! Lol

2B

Its really funny that you mentioned that. I just posted my own story of being caught wearing an ADS on another thread. Weird. Yeah, I gave up trying to wear it at work because it hung too low to be discreet. I have looked into those rubber band stretchers but I have this dreadful thought in the back of my mind of it giving out while I’m busy with a client and it snaps back on my balls.OOOOWWWW.

Yes m8.

It is really great and v comfy to wear. In place of the slingshot rubber I use theraband. It is a great setup tbh. Is very similar to monkeybars autoextender/vac set up.
Go for it.
The only down side is the glans can get a bit edema after a few hours. Maybe I need a larger cup or taping the glans

Good luck

Sounds good since the weights I have are now too small and I can’t fit into them. That could be my new alternative.hmmmm. Very good advice.

I saw how the Circle Device was made, and measured.
What is your EG now? (6.25” according to signature)
How much bigger is it, why couldn’t you modify the
Circle to still work? I want to make one similar to the
Circle Device, but with Tungsten which is extremely heavy,
Nearly 60% more dense than Lead, which I believe is more
Dense than Pewter. It would only take a small (in size) weight to get 3 or 4 pounds.

I read of a study in England, I believe, where they stated that 2 kilograms
(4.4 pounds) worn for 6 hours a day was the key to triggering Penis Growth.
Well, being a “somewhat scientific mind” I surmised that figure was actually
“26.4 #-hrs” and one could actually wear a 27 pound weight for 1 hour
And get the same effect! Maybe? But the reverse could also be true, and a
Guy could wear a 1 kilogram weight (2.2#) for 12 hours and get the same result.
That is the route that I ultimately took, wearing a light weight for longer times.
My same weight was hitting a lot lower when I wore it steady for over a year!
I was getting 10 to 12 hours + a day, 6 and 7 days a week. I also wore it to bed,
Threw it over my thigh and got a bit more tug. I actually would guess that I was
Under 2.2# and maybe just around 1.5# or so. I actually weighed it at one time,
Then increased the weight, but could not weigh it again until I got my own digital
Scales years later. Right now I have enough on there to duplicate or slightly
Exceed my prior setup in weight, around 1.6 pounds right now, but I have
Extra _compact_ weights I can add to go over 2 pounds, maybe even 2.5
That is a big wad of metal, I would need a smock or lab coat for sure!
Another drawback, I use the padlock method, and the lock has been
Widened, but it’s getting too tight and tends to actually abrade the skin.
If it actually bleeds, it’s days lost for hanging. No Good!

So I need a new setup, I believe. Glad I saw your Circle Device! I can make
An improved version of that, tailored to me. Using their “theory”,
I may try and go mid shaft instead of really low like I did before.
It might not work as well for me, but my version should work either
Location!

How did the mid-shaft hanging work for you?

2B

Found this:
Lead Free Pewter, density = 7.2 grams/CC
Lead.= 11.3 grams/CC
Tungsten.= 19.4 grams/CC

So the Tungsten weight would be about 1/3 the size of the Pewter weights,
And a little over 1/2 to 5/8 the size of Lead weights. Cool! That means I could
Use a plastic covering of some sort, for comfort, without adding size as
Compared to using lead or pewter weights. Still Smaller.

Probably can find bars and make them into thin rectangular tabs that
Can be made into two clam shell halves, like the circle device. :D

You know, the whole hours/weight thing has always intrigued me. I haven’t done much hanging, but, seeing the results makes me want to try it and finally see the 10” both my wife and I want. Tungsten, huh? Do you have a shop available to machine it? I’m a mechanical test engineer by trade and I work off of observation, theory, and experimentation. My EG back when I ordered the device was a flaccid core size, which is what it shrank to at the time. When I bought it, I was maybe 5” around erect. Now, I’m 5.25 while flaccid.hahaha. Yes, you can shave it down to open the thing up and I may see myself going that route since its too expensive to simply buy another. Just bought some more thereband to wrap with, so I’m hanging with 4+ pounds again like I did in the good old days. Hopefully it will work as well this time around. Mid-shaft hanging allowed enough skin to prevent slippage of the Circle Device. We’re in the same boat.. As the girth increases we have to come up with new ways to attach stuff.

I just finished checking out his website and the product looks promising however I’m not sure how they handle guys who are cut like myself. I’m not interested in re-creating a foreskin for myself although I know it’s popular but it’s something I would prefer to avoid and just focus on length. Congratulations on your gains. It states to connect the circle device midshaft but is it possible to just have a string of weights from the base of the pubic bone to just behind the glands with some additional wrapping?

Let me know your thoughts