Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Extender Question

Extender Question

Hi all. Been doing plenty reading. Have been extending for 2 weeks with peni master pro. I used just a slight stretch for first 3 days. Then just used screws to slightly increase daily after that. Got to the end of threads and within few hours it was basically no tension so changed the rods over and put screws right Down again found what was good and set of again. Now after few days was back to screwing threads out after few hours to keep the tension and that then stayed the same for few days. But this last few days I have seem to have felt it needs back down as its feeling like too much pull. Question is. Is that normal that it’s eather trying to heal and my body is trying to retract that stretch as its healing or is there something else a should be concerned about. ? Do warm ups before stretching and warm down after. Just confused why it felt just fine and now feels like way too much. And info would be great thanks.

ah, well, your willy is shrinking.

Nah, joking.

You prolly overdoing on the high tension. It’s hard to explain what’s the right pull for you. Try to cycle it, let’s say you wear it for 1 hour. Go 20 minutes low tension, then unscrew to mid tension 20 more minutes, then unscrew to high for 20 minutes. That’s 1 hour. Repeat as many times a day as possible (or impossible). Try not to get carried away on the high tension, exceeding 20 minutes will be painful AF to remove the shit off your dick. As you’re a noobie, I guess even 10 minutes at highest will be impossible to bear. And by highest I mean when the spring is max compressed.


inicial 1996: BPEL 15cm (Margin of error +/- 0.5cm) MSEG: 14.1 cm

inicio extender (sept2012): 15,5cm BPEL /14,1cm MSEG --- Hanging: inicio: Ago 21 2022 21.0cm --- Ultima medicion: Sept 1 2022: 21.6cm BPEL x 15,1cm MSEG

Meta: 28cm BPEL x 21cm MSEG -- si, quiero tenerla mas gorda que tu vieja. jaja

Well a hope not haha! Yea a usually adjust as the time goes by when it feels like it’s slackened off after initially putting it on. Maybe just moved up sooner than I needed too. Thanks for the suggestions. Hopefully every runs smoothly from here on out

I’ve had to remove rods after adding them a few times. Usually I just get all excited and add a rod too soon.

Don’t add a rod till you CONSISTENTLY max out the threads every time you extend.
And don’t try to force faster progress when you make noticeable gains. If you gain, that’s great. Just try to keep that length and let yourself heal/grow at that new length for a bit.

Yea thanks for that. Sound advice can visually see difference already. Flaccid has really improved alot. Didn’t think would notice any girth changes but for sure it’s thicker maybe just tissue swelling from stretching I don’t know but all is going well so far

Top
Similar Threads 
ThreadStarterForumRepliesLast Post
Size Doctor Vacuum Extender , Light Vacuum Extender Andracle Slide Extender For SalemorbidangelPenis Extenders1112-17-2021 04:49 PM
JES Extender. Does an Extender actually workmoto_x_man72Penis Enlargement Basics811-08-2010 10:01 PM
Problems with vac extender, which is next best extenderbasil1492Penis Enlargement Basics703-21-2009 11:50 AM

All times are GMT. The time now is 09:52 AM.