DIY BIB hanger

Here is a crude illustration of the homemade alternative I mentioned in reply to Prickle’s post…

Since many of these clamps have little teeth or grips or whatever inside (ouch!), I just wrap it up well in the rubbery self-adhering sports wrap tape… makes it very padded. Also, file off any sharp plastic corners to ensure that your scrotum doesn’t wind up getting poked…

I’m simple minded and don’t understand. Can you please explain how that contraption works? What is the thing on top?

LOL

Like I said, apologies for the crudeness of the illustration…

…the thing on top- if you’re referring to the thicker black line that arcs out- is bent wire. A section of thicker gauge wire is bent into a v, and the ends then bent downwards and inserted thru the screw mounting holes on the clamp base. I used a cheap hose-hanger mount for this, which is essentially just a pre-fab version of the bent wire thing. However, the ends are meant to be nailed into a wall so need to be filed down (sharp things + penis = BAD!)

If you are familiar with the type of hose clamp I am referring to, the key is to just take it and turn it upside down so the wall/floor mounting flat surface is on top of the shaft. This mounting surface is then attached to the bent wire “V”…

Does that make any sense?

Hmmm.. I still don’t get it. Can you post an actual photo?

I don’t own a digital camera: however, I will see if I can borrow one…

With the good news that Bib will be building the real deal again soon, hopefully this thread may become obsolete.

How much pressure does it put on the nerves on the top side, below the glands of your penis? That’s a sacred area. Usually these “all round” hangers aren’t good for you, just because of the aforementioned. For example the notarious “sock hanger”.