Hanging properly with VacHanger

I am having trouble hanging correctly with my VacHanger.

- I wrap a 18” long Ace Bandage 1 inch below glans
- I put a 18” long Grey colored Theraband slightly above the bandage
- Then I put on my VacHanger and roll the sleeve up above where the Theraband ends

I then put the VacHanger (10lbs ) on and the sleeve starts to stretch like its about to rip when I let go of the weights. Is there a correct way to wrap while using a VacHanger without ripping the sleeves?
Below is a pic of my situation.

I don’t know much about hanging sorry but I am really thinking about trying it.

Is 10lbs a good weight to start off with?

I also will be getting the vac hanger so some info from anybody would be great

10 lbs for a beginner is NOT a good weight to start with.

I have monkeybars vac hanger. I use talc powder on my head and shaft. It seems to stop most of the slip. I also wrap and then clamp on top of the hanger setup. I can hang 7.5 lbs for 1+ hours no slip. Remember air and slack in that hanger is the enemy. Make sure you have no air and it is tight. Good luck.

P.s 10lbs is too much to start with. I started with 2.5lbs then 5lbs for almost 2 years. I just started 7.5lbs this month. Less is more sometimes.

I don’t wrap with my vacu hanger. I do, however, put a cock ring around it to seal it, since I noticed that, after some use, the sleeve is no longer very functional.

Guys I will try to lower my weight down to 7.5 lbs or 10 lbs. But how can I fix my problem if the Sleeve that is almost about to rip when i hang? The tension when the sleeve stretches is really uncomfortable to my penis.

KT,

I think wrapping would mess up the air seal with the vachanger. The length and tightness of the sleeve should keep air from seaping in. When the vachanger is on properly it is the suction around the glans that is holding it on. I have successfully hung 15lbs. with it. The most effective hang is seated over a drumstick or a rice sock.

I use autoextender.com’s Vacuhanger, although I don’t believe they sell it anymore? I have found that saran wrap, along with a padded piece of tape for the tip is the best wrapping solution. It really prevents blisters and fluid buildup and holds everything snugly. I used to use the constriction sleeve, but not anymore. I hang 10 lbs with no problem.

Ktsevens- Are you using the vacuhanger from autoextender.com or a different product? If so do you have a link where one can check it out?

I have an homemade vac-hanger that I built regarding the monkeybar`s vac-hanger.

This is my 4Th week of hanging an I`m doing it with 5pounds , next week I will increase the weight to 7.5 pounds.

After a hanging session with 5 pounds I can feel very well the tension on the ligs so the 5 pounds and my hanger done they-re job.

Read this Hanging 101 + Sample Routine and look on the routines of guys that have gains from hanging that will help, you will see there that even 7.5pounds it`s a big weight to start with.

If you’re just starting out 10lbs is too much weight. Also, when you put the device on make sure your glans is flush with the end cap. If there’s any space at all between the top of your head and the end cap you’re going to get some serious blisters. So make sure you smash your glans in the cap as you release the air to form the vacuum.

Can you please explain how your wrapping with saran wrap.

I have a vac hanger I use for ADS but the constrictor sleeve is about to give out. When I try it with out it I can tell I will get a blister so I have to take it off pretty fast.

Master- I cut a piece of saran wrap. length- enough to wrap 3 times around the tip. width- about 1.5 times the length of my penis head. I wrap around the head to a bit below. I determined how far down I would wrap by seeing where I would swell when I wasn’t using a wrap or constriction sleeve. Just wrap around tightly, give it a bit of a squeeze to make sure the saran wrap is nice and tight. The tip will remain uncovered because the saran wrap wont’ stick well on it, so I use the tape that I got (when I ordered an autoextender package) and just place it on the tip. I still get some fluid buildup obviously, but not nearly as much as with a constriction sleeve, I’ve found that the constriction sleeve always leaves a gap at the top and the tip of the penis will always get red and sometimes blistery. I hang 10lbs straight down for an hour every day, very comfortably. I will try and increase the weight soon, not sure if these autoextender blue sleeves will be able to handle the extra weight, we’ll see.

Question for all- Has anyone used monkeybar’s red heavy duty sleeves? Does he sell them anymore? In a recent order I requested a couple of them, but got sent the blue ones instead??

I have the red one but it was to intense for me to use. Whether he still sells them I don’t know. Hit him up on one of his two threads, he usually anwsers product questions quickly.