My DIY ADS hanger
Hi guys.
Early on into my PE, I found that I would get great results with stretching, but then after a few minutes everything would shrink back down. My natural inclination is that length growth will be better if the penis is maintained at a more relaxed flaccid state than in a shrinkage state.
I had bought a 1” steel ball with a silicone strap that had 2 little magnets to hold it on, but it kept falling off and the weight really wasn’t enough.
So I made this little fella. It’s a 1.5” stainless steel ball that I cut a Y-shaped hole into and is held on with rubber surgical tubing and a little plastic clamp, like you find on drawstrings.
I sourced the ball and clamps [10 pack] from Amazon and I got the tubing off eBay, being sold as material to make custom fishing lures. The raw materials were about $20 and then, naturally, I broke about $50 worth of tooling putting the holes in it. Turns out the SS was hardened as I got into it…
I calculated the weight at approximately 210g, compared to the 70g of the original 1” ball I’d had before.
The strap fits in the sulcus behind the glans and only needs to be minimally tight to prevent it from falling off. The weight is enough to pull to a gentle stretched-flaccid length and I can wear it discreetly at work, comfortably for 2-3 hours at a time. I’m still experimenting with whether any sort of wrap allows me to wear for longer before it gets uncomfortable, but I wanted to share with the group.
