Sirken
Very interesting looking hanger. I do not fully understand what you made it from, but I am familiar with the AFB design and concept.
<1- How do you wrap? Do you retract the foreskin or leave it covering the glans?>
My wrap is based upon the wrapping thread at the top of the hangers forum. Prior to applying the wrap I do pull back the foreskin to expose the glans and at the same time I stretch out my penis. With the other hand I begin wrapping with the light sweat shirt material. One strip approximately 3” x 9”. This gives me about 2 complete wraps around my penis. When the sweatshirt material is applied I keep it just above the rim of the glans for protection and try to wrap it snug. While holding this in place with the same hand you are extending your penis with begin wrapping with the thera / cut swim cap material. (I use a 2” x 14” piece of swim cap). Start about 1” below the head. Wrap snug getting tighter as you spiral towards the base. Towards the end of the final wrap I can feel a tight grabbing sensation inside my shaft. Then apply the hanger. After applying the hanger I wait for a few minutes before applying weight. This accomplishes 2 things. 1) allows the head to swell up and gives a better “wall” of resistance for the hanger. 2) I get boner issues after I wrap sometimes, the extra time allows it to subside.
<2- Have you experienced any discolorations on the foreskin? any idea how to avoid it?>
Yes, I do suffer from that. I think it was mostly due to poor wrapping techniques in the beginning. My discoloration is primarily on the skin just below the level of the rim of my glans. What I have found is that I have been able to reduce it by making sure I apply the hanger at the bottom of the elastic wrap. This leaves approximately 1+” of cushion above to absorb the pressure. I think the discoloration is primarily from where the skin pinches and is put under extreme pressure. I have also found that when I took a week off of hanging and did just jelqing exercises I was able to reduce the discoloration significantly. For more info about that look under a thread by Bib labeled “wrapping to remove discoloration” (I think).
<3- Is this hanger no good?(since the sides are not solid rectangles, maybe is exerting more pressure on the glans)>
I’m not too sure. I personally did not have much success with the AFB. I use a modified Bib. I have had to make about 10 different changes that customized it to my liking. If you are crafty look at the “Homebrew Bib” thread stared by ‘tryn’ in the main member section. He created a Bib knockoff that has promise. I am going to make one my self! Once I got my wrapping technique down pat I experienced a much more comfortable hang.
<4- Can I hang for more than 20 minutes? Yes/NO (there are so many conflicting theories here)>
I hang for approximately 20 minute sessions. It depends though, I try to monitor my penis for the duration of the hang. If I’m too cold or getting numb I stop immediately.
There is really no clear path that you should follow. It has to be more of a customized plan that works best for you. I would recommend that you educate yourself as much as possible with the resources of the forum. If something isn’t working then do something different, but always listen to your body. That is how you safely determine your limits. There are always better ways to accomplish your goals. This is a long journey, no pun intended. I hope that this is helpful.
Good luck