No wrapping needed with the CCH3 hanger?

I need especially the uncut guys to give me feedback on this because I’m not sure how big of a major discovery this is ( I am cut ). Here is a link that shows dk75 hanging without wrapping with the original CHICKENCHOKER HANGER, the CCH1. He’s only using 3 lbs here.

My Two-dollar Chickenchoker Hanger!!

I didn’t think this would be practical at heavier weights but now, I just finished my third set of 20 min. using 10 lbs. without a wrap with the CCH3! While hanging, there is a noticeable amount of skin stretch involved but beyond the discomfort of adapting to that, it’s still very comfortable. I tried using 17 lbs. just now ( briefcase + laptop/case ) and was able to handle it for 3 min. until the skin stretch and the lig pull became too much since I’m still getting used to 10 lbs. with the skin stretch. Note: the heavier the weight, the tighter you must manually get the pillars to pinch on your dick. Believe me, it doesn’t hurt. This extreme tightness must be done manually to overcome the cord friction against the pillar holes.

Using a wrap makes the internal structures bunch well so a hanger can use the bunch as a grip. Without a wrap, you would need more skin from the base of your dick to act as the bunch for the grip, therefore you would need to start with the hanger closer to the base of your dick so it can start grabbing "early" for a hold there to still end up far enough from the glans for comfort. Would you want the comfort of using no wrap but MAYBE getting a bit more foreskin to go along with it? It’s possible too that increasing the weight means needing more skin to grip with. Now that may be impractical, which means by the time you get to 20 lbs., you have bunched up enough skin to restore your foreskin ( if you are cut ). However, hanging with 10 lbs. doesn’t require that much of a gripping bunch, so the skin you might gain with 10 lbs. will probably be only noticeable by you. And if you want to stay at 10 lbs., just increase your hang time - if you have the time.

The gripping surfaces of the CCH3’s pillars are 2" tall. Tall enough to cover the extreme flattening of most flaccid dicks against them. If you have too much girth, just make a magnum-sized CCH3. There are no sharp edges with the CCH3 if that is your concern of having to use a wrap. There is no slippage - the gripper surfaces seem to nearly bond with dick skin like a barnacle’s grip, in fact, you have to peel it from your dick at the end of your wrapless sets. This is a drawback to wrapless hanging since you slow down the removal speed of the CCH3 from 1 second to 5 seconds - aw shucks. No more "BOOM - it’s off".

My question to those uncut is: why mess with having to bunch up the internal structures with a wrapper when you already have a foreskin and don’t mind to have maybe just a bit more? In fact, whether you are cut or uncut,the adding of extra foreskin may not happen when hanging under 10 lbs. because of the minor amount of skin bunching needed for the hanger to grip at that weight.

I have not tried a Bib Hanger since I don’t own one and would not know if the same principle applies to it or if maybe a part of it’s design while in use necessitates a wrap.

I just trip over all these posts about problems with wrapping for the uncut guys and I’m just trying to see if the CCH3 alleviates most of their problems so they can be as happy as these guys:

:jumpers:

Thank you all for your feedback.

Want to see me hanging with the CCH3 without a wrap?

I got a top view and a side view.

The CCH3 in action.