Best Source Of Constant Heat

Lol no chance I’m doing that. I went w the thermipaq 6x12 and It gets the job done

In the morning i shower with water pointed at my member, then pumping with heating pad wrapped around cylinder…

Has anyone used an IR heating pad? I guess the heat penetrates deeper than an electrical one but I don’t know for sure.

I use a 12” plug in electric thermal pad (same length as tube I have), and I keep it wrapped around the tube, secured with rubber bands at the top of bottom. I “pre-heat” the tube 10-15 minutes before I start pumping, keep it on through the pumping session, but periodically undo the top rubber band and partially unfurl the pad to check in on the action underneath.

I bought a 150w ceramic heater that screws into a light bulb socket. net.lore says 20” is the best distance, but I can use my laser thermometer to see that my skin temp is to make a fine adjustment. I haven’t got around to trying it out yet.

The lamp is just a white ceramic plate; no actual “bulb”. It was under $10 on eBay.

I personally use a heating pad that I have acquired from Amazon. Works like a charm.

I never experienced a donut in 32 years of vacuum cylinder pumping without heat.

My first donut earlier this year was after reading suggested heat and duration “advice.”

Now I occasionally read online advice and suggestions for a good laugh.

Good luck.

32 years? Can you please tell us about your growth and PE experience after pumping over three decades :) ?

Yes please elaborate!

Heat seems to be beneficial to everyone else. Maybe your duration was too long.

If you think online advice is for entertainment only, should we also be laughing at your advice?