Bollock Lengthening

I have recently started to drop my balls into my cylinder and pump. However I am not sure how long to do this for. I currently last a few minutes and stop, this is at 5hg.
Any advice would be great and also at what time/pressure did you see gains in lower hanging spuds?

Kindest Regards

Willy

I don’t have advice, just a couple of question. Both balls at the same time? I tried this yesterday but it was difficult to insert both, maybe because my cylinder size is 1.75 in / 44 cm.

Any pain?

I have a 2.5 inch diameter cylinder. I hold against my balls and pump. They then get sucked in and is comfortable.

I did get a 1.75 cylinder but it just didnt work for me as it was just impossible to ise so I went for a 2.5. It certainly helps with temporary girth gains.

Make sure you’re using constant heat. There should be a pull but no pain. I’ve posted some pictures of my post pump balls towards the end of my thread.

In my 1.75 in cylinder, I could only get one ball in. I kept it on for 5 minutes at maybe 4-5 hg. Slight discomfort. I guess ball-pumping requires a bigger cylinder.

You may need a 2.25” cylinder. I’d like to get a larger one just for ball pumping.

I’m pretty sure pumping increases the hang of the testicles automatically with regular use. That seems to be the case for me anyway.

My thoughts are that the pulling of the scrotum into the tube when starting a larger tube it stretch it out over time. The increase in scrotum length from this allows the testicles to hang lower and gradually lengthen their cords. There seems to be a correlation between dick size and the length the testicles hang as well, probably due to the warmth of the penis keeping the testicles dangling instead of retracted.

Or maybe my testicles are hanging lower from age. I don’t know, but I’d prefer they’d stop. Low hangers are attractive I think, but this is fast approaching ridiculous and briefs are so uncomfortable and stretch out of shape in a few days.