Do you warm your cylinder?

I only tried wrapping the cylinder in a heat pad once and it scared the shit out of me. When i unwrapped it to take a peak at what was going on i was quite worried. Usually my dick in the tube is an encouraging sight, I usually have great expansion but this time my dick looked sick and malnourished… all purple and shriveled. I will probably give it a try again but this was a bad experience…

Anyone have a negative experience with wrapping the tube?

I can’t imagine how the heat pad had anything to do with that.

Yes sorry I should’ve mentioned the size. I think they claim a 9x2 cylinder. However a reviewer on amazon.co.uk has given the exact dimensions which I can confirm

“As we all know size matters(!) and product info is notoriously unreliable so I am here to make sure you know what you are buying. The cylinder is completely parallel sided with quite thick walls. Internally you have 230 mm of length and internal diameter of 54mm this translates to ~ 9.5 inches of length and 2.125 inches of diameter. So whilst not HUGE this is quite a large tube already. I would not recommend as a starter tube for anyone less than average sizes”

Yea who knows… so heat translates to better and faster gains?

Always use heat.

Yea I always warm up but what’s the difference with wrapping the tube vs not? What difference have you seen and noticed?

Do I have to wrap or can I stand in front of a heating fan during my time in the tube?

You could, but I prefer not to heat my entire body and the room I am in. I prefer wrapping the cylinder in a heat pad to focus the heat where I want it.

i do not warm my cylinder actualy and i can stay much longer with zero bad effects, no donnut, no lymph, no turtling after, no pain when i pee….

i am amazed how better i feel when i pump cold.

i can stay more than 2 hours in when i pumpu cold.

while i can only stay 45min in when i pump hot with donnut, lymph and turtling and light pain after.

@Summer - do you enter the tube erect?

Ok yeah makes sense… Thanks

Hi guys….used to wrap with a cheap electric heat pad from aliexpress.com and I can feel the warmth. I do start with warm up with hot wash cloth, then some stretching. Then 100 jeqs and after enter the warm tube which is already warm by heat pad. Currently doing 2 minutes 4hg pressure and then 30 seconds release pressure x 8 times. After this 60 jeqs and some bending followed by a small edging session. My question is do I need to warm down using a hot wash cloth? If i do so my size become less after 3 minutes of warm down. What do you guys experience…pls share…thanks

No, i build my erection in the tube gradualy.

Today I tried again to pump with the heat pad but this time with the minimum heat for only 50 minutes with a ring.
I made a cut at 25 min and I resumed to avoid the edema.
It went rather well.
I will continue like this because I do not have edema, and less fatigue.

i have been experimenting for so long to find my routine, i think i will get there eventually…

Any comments or suggestions guys!