Do you warm your cylinder?

Do you warm your cylinder before pumping? I dont like mine when its cold.

I turn my oven on the lowest temperature and put my cylinder in for a minute or two to prewarm it and then while pumping, wrap the cylinder in a heat pad to keep it warm.

I have the same procedure.

I don’t think mine is ever especially cold. It just lives in the closet in a box.

I wrap mine in my heating pad on low while I jelq. Then I turn it to high when I enter the tube and then adjust setting as necessary. I think it’s much more comfortable entering a warm tube

I use hot water in my cylinder. But how long are you guys in the pump for? I try for around 40 minute total sessions with 7 minute intervals 30 second breaks.

I wrap my cylinder in the heating pad before I begin.

+1

I dont care, i go in cold and let it heat because i stay in for 1 hour, it is enough if i got 5 min cold and 55min hot haha.

I warm it with the heating pad while I edge for 10 minutes. Keep the heating pad on throughout the whole session.

Yeah. I warm mine while I stretch. :)

I never considered a cold tube to be a problem. It warms up quickly.

Hi..I used electric heating pads on the cylinders…I used to pre warm the cylinder before i start and when i enter in the tube it will be warm already. I am having leluv cylinders and the measurements marking on it is erased because of the heat application i beleive. So i need a permanent ink to re mark it again. Anyone experienced this issue? I have another idea to dip the tube in hotwater before start pumping and then wrap with hot water cloth. I am afraid the tube will break if i dip in hot water.

Thanks

I use a red light therapy type heating lamp. I’ve already used it for 3-4 times, while pumping and outside the tube as well, it seems to take discoloration back to it’s normal colour.

I use a permanent marker to mark my points if jnterest, then place a piece of clear packing tape over it. The tape protects the ink from erasing.