Does anyone's Ball's tighten to the base while pumping

I have always had a tight sac. When I pump in the 1.75” for length it isn’t too much of an issue for me. When I step up to the 2”, my balls are right under the seal, and are very tight. So much that there not hanging vertically(long), but more sideways(wide). I get a small ache in the balls, but nothing serious.

I am always trying to loosen up the sac by doing manual ball stretches, but not much progress.

Anyone else experience this? Anyone have any tips?

I don’t think there’s a remedy, so ill just have to deal with it.

It’s happened a few times with me. Try putting a cable clamp loosely around the balls to keep them away from the cylinder. Try different padding or wrap to aid comfort. However, If your sac is pretty tight you may have a time getting the clamp on. Or there’s a leather strap you can get at adult stores to wrap around your scrotum. Hope this helps. Good luck.

Have you ever tried putting you nuts in the 2 inch tube and pumping them? Or better yet 2-stage pumping? Either one of these will help to loosen up your sack.

Both good ideas. I will try a cable clamp, or a silicone ring.

The 2 inch tube is way too small for package pumping. I do have a bullmaster as well for package pumping. It does give a nice pull on the scrotum, but the opening is pretty large, at least for me to get a solid seal. I have to spread my legs apart, for it to seal at all. I’ll give the bullmaster another run tonight.

My balls slip up there too when my dick isnt filling the tube up completely girth wise… its rather uncomfortable. Is that unhealthy? I can’t imagine pumping your balls being good for them =/

I think the key here is to under no circumstances allow your balls to be accidentally sucked up into the tube.

The pain will be more than you most can handle. “You know the definition of eternity…? The time between when your balls get sucked into the tube and time when you can get the tube off”

Ball pumping is a good feeling as long as you are ready for it and for gods sake, take it slow and easy.

Kushextender I didn’t make myself clear (sorry about that). I meant try putting your nuts by themselves in the 2 inch tube. This will give you a good stretch. Also, instead of the Bullmaster for full package pumping, try starting in something smaller like a LongJohnny or even a larger straight walled tube say a 2.75 or 3 inch tube. After that you can work your way up to a Bullmaster and not have as much of a problem with sealing.

Hope this helps.