How do you keep your scrotum out of the pump

OK guys, one of the most irritating things is trying to keep your scrotum out of the pump. Do any of you have some special techniques to keep the scrotum sucking to the minimum? I try by pulling my balls down while at the same time pressing the cylinder against the pubic bone and pumping with another hand (I use a hand pump). Logistically it is a nightmare. Anyone wants to share their technique?

Having the correct size cylinder helps a lot. What is your erect girth and what is your cylinder diameter?

Keeping lube off your scrotum also helps.

I agree that the correct size cylinder is important. Also, someone here suggested lightly clamping around your scrotum to keep your balls from getting sucked in. Ought to work.

In addition to what gprent says, I also use a comfortable gummy cock ring around my ballsac which keep my nuts from being sucked in, especially when I’m using a larger size cylinder.

Peforeal

Well my cylinder is 5,5 cm in diameter and my circumference on the girthiest spot (i have a baseball bat:-) is 15,1cm.( i am very bad with inches lets see 5,5cm is 2 1/4 and 15,2cm is 6 inch) it is not that the nuts slip inside but that the suction grabs them and pulls them up right to the opening of the cylinder. So i try always to pull them down. But it kind of is slightly painfull.

If you had a 2” cylinder it would probably solve your problem, but that is a rather expensive solution. In addition to the above suggestions, you can also try stretching out your scrotum as much as possible before entering the cylinder so your balls are hanging as low as possible and therefore farther away from the evil suction. :)

That solved the problem for me too. Maybe your cylinder is 1/4” too big. But if I were you, I would really give try to the jelly ring around the ballsac.

gprent if my cylinder was any smaller I would not be able to get my cock inside. I will try stretching my balls to hang low. It is only that I get lube all over the place:-)

I don’t mean to state the obvious, but stretch your balls out first, then carefully apply your lube. Also have a small towel handy to wipe off your hands so when you are pulling your sack out while pumping, everything on the outside if the cylinder stays lube free. Eventually, you will get it all working.

Practice makes big. Or so I hope:-)

I’m with peforeal and Powpow. I also use the silicon cock rings and those silicon handlebar style cock rings, and 1” width leather ball straps. They all work. The leather ones have now become my favourites, as all silicon rings which come into contact with oil or lube, eventually perish. The suppliers constantly change the styles and if I find one which is comfortable, sure as anything it won’t be available again when I want to replace it. Leather ball straps can be uncomfortable at first, when the leather is stiff. The solution is to wear them as long as you can tolerate, so they get broken in; like comfy shoes.

Those very wide blue rubber bands that brocoli, asparagus, etc that are in bunches in the produce section of the store ARE great for this. Save them and use them until they wear or break. They fit loose enough to not cause any blood restrictions or flow problems.

I cut an inch off one of Monkeybar’s silicone sleeves and then wear it around the ball sac. It works well. The scrotum never slips into the tube.

Rhadames