How to create more pressure on head

I was just wondering if anyone has any advice how to create more pressure when pumping on the glans only.

Is there a way to create more pressure at the glans instead of the base.
I have a 2.0" pump and I find that I pack the tube to mid girth. I go from around 5.5"-5.7" girth to 6.2" once I am done pumping.
Which shows that I have packed the entire size but from MSEG to the glans I struggle to pack or feel any pressure on the glans.
The only thing I notice is that my foreskin above my frenar band gets edema.
I’m uncut and my frenar band is quite tight below the glans but I can retract it fine. It most likely is the cause of tightness and trapping edema in the foreskin.

Does anyone have any advice how to focus the pressure on the head of the penis instead of the base. Am I doing something wrong or does the pressure start at the base?

I have only started incorporating Pumping into my routine end of May 2023 a few months back so I am no expert. The system I use, L.A.Pump has a special pump on their website that allegedly allows one to target the glans.

I have not yet purchased this product nor used it so I cannot speak to its effectiveness other than to point to the claims on their website.

I am noticing already, only a few months in to my pumping routine, that the glans is just beginning to show signs of a tiny bit of “under development” relative to the rest of my penis.

I see this simultaneously as a good thing telling myself that this undoubtedly shows the other areas of my penis thickening, unless of course my Glans has shrunk(NOT the case), while also simultaneously noting that perhaps in 6 months to a year I will need to make a purchase for the LA Pump products that targets the glans so as to get a more proportional overall balance.

Thanks meiguoren, I know of it too.

It’s an expensive option. I was hoping of a way to use my 2.0” cylinder as I already pack this one and was hoping I could find a way to stress the head more with some technique or method.

Does anyone know if this will work?

https://www.new art.com/pump/ar … 98/mushroom.htm

You might want to try a spots handle grip tape:

1roll Sports Fitness Tennis Racket Non-slip Sweatband | SHEIN USA

Some guys have used one or two silicone sleeves on the shaft, cut off at an angle to give the glans some room while pumping.

Thank you dtwarren1942, how does that tape go under pressure? I have found that some tapes I have used tend to stretch and thin out causing it to stick to the skin and compress it too much.

Thank you AndyJ, I have tried a silicon sleeve but I find that the more I pump it slowly slides up the tube over the glans and eventually comes off. This could be due to the shape of my shaft being thinner the closer it gets to the glans.
I find that if I do not have a perfect seal my foreskin slowly slides out and then it risks ballooning which I want to avoid as that skin is the most sensitive below the glans.

Huh. Are you putting the sleeve on while dry, or are you using lube?

My main problem with the sleeves in getting the freaking things off!

Seems like an excellent idea. Will try

If a silicone sleeve slides off, I expect the plastic bag under the electrical tape would, too.

Still, it would be cheap enough to try.

Give me a day or two and I shall experiment
And report findings here.

Silicone sleeve without lube may not slide off

As is plastic bag with electrical tape wrap

You can use a piece of "theraband" or something similar. Put a few wraps below the head extending about 2" down the shaft. No need to tape it and it doesn’t have to be super tight. You’ll need some lube on the outside of it so it’ll slide into the tube. The result after you get the hang of it will be little or no foreskin edema and more pressure on the head.