Length at different pressures
I have a pump that does not have a pressure gauge attached. I know I could buy one, but would prefer to not do so if I don’t have to. To this end, I would like some idea as to how much pressure (suction) is being applied to my dick when I pump.
My cylinder is graduated and always shows bone pressed length as soon as I start pumping. For those interested, I am using a "Handsome Up" system (see http://www.wild secrets.com.au/ … k.html?aid=1520 ), filling it with hot water and keeping it hot with an infra-red ray lamp. I am careful to not get water into the pump and regularly spray metal parts with a water repellent spray. I do two 15 minute sessions most days with a five minute break between and five minute warm ups and warm downs. Note, my cylinder is 20 cm long to the start of the cone, not 17 cm as suggested on the web site, and is 5.8 cm in diameter.
A question, please, for those who have gauges: In relation to BPEL, how long is your dick (bone pressed) in the cylinder at 4, 8 and 12 in/Hg. Following the advice I’ve seen posted elsewhere here, I pump until my dick is about 1.0 to 1.5 cm short of BPEL. However, I have no idea what pressure I am applying at that length. Am I overdoing it, not applying enough pressure — what? If I pump until I reach BPEL, how much pressure am I applying. Thanks.
Last edited by RickM : 03-22-2010 at .