making custum sleeve / donut?

hey guys.

I’m looking for ways to make a good seal, and have seen many references here and there about inner tubes etc.

Maybe I didn’t give it enough of a go, but my advanced search for “making donut” “inner tube” “sleeve” etc etc didn’t really help me find what I’m looking for.

Sorry to be a bother, but if anyone could point me in the right direction (links to threads) or even just quick suggestions to making a a really good short sleeve / “donut”, I’d really appreciate it!

FW

p.s. I had a really good one that came with a novelty store pump years ago, but it’s wearing down / cracking…

To make a good seal You need to have good contact between the tube and your body. So you should remove as much hair as you can . Just leaving a stubble (to avoid getting funny looks if you shower at a gym etc.)

Then when you want to pump; Put some hand cream around the base of the pump. Then dip the pump end which is going to be next to your body in some warm water place it over your penis and as you push it down on your body rotate it against your body .

Keeping it against your body start to pump until you have a good seal then just take the vacuum up to the required level

Hope that helps.

Petit

thanks Petit!

but still, I find I never got as good seal as with the gasket device… I’m shaved, but still, sometimes I can loose the seal.

Thanks again though!

FW

http://www.bigs extoystore.com/ … logno=SE1045-00

Or check the making a sleeve link in my signature.

If you want to buy a replacement, try going to amazon.com and searching on "penis donut sleeve".

You might also want to look at the Homemade Tubes? thread. One solution suggested there is Plasti-Dip.

The Differential Diagnosis for Vacuum Leaks thread also has suggestions on improving your seal.

thanks guys!