Originally Posted by peforeal
all4show,Well, I use lots of lube on my dick before entering my 2” tube. I’m smaller in the glans area and bigger on the lower half of my dick, so it’s not that difficult to suck my lubed dick into the cylinder under vacuum pressure. When I enter, I pack the tube immediately on the lower half of my dick, and it takes me about 20-30 minutes to pack the smaller upper part of my shaft.
I usually start in the 2” tube first and then move into a 2.25” for another 30 minutes or so, taking breaks every 10 minutes or so. I also occasionally use a 2.5” tube. I originally started in a 1.75” cylinder years ago.
As far as consistency goes, I have a definite girth demarcation on my dick. From midshaft to base, I range dramatically from 6 - 7.25”, and from midshaft to right below the glans, I range from 6 - 5.25” or so. I have what I refer to as a tree-trunk or elephant trunk shaped dick.
My current girth goals are to equal out the girth of my dick from base to below the glans. I can achieve this result after pumping, but I’m working on this more symmetric look even when flaccid or unpumped.
Your shape sounds like mine, I have tree trunk shape too, but I am a few years behind you. I started with a 1.75 and only used it a short time, it actually hurt at the base. I now use a 2” but I am already that size on the bottom normally and it does not take long to pack 80% up the shaft. It seems I am losing some effects of the pump if I do not move up? Also, it seems I am not as long and often measure shorter in the 2” tube. Would it be wise to move up or stage pump with 2” and 2.25?