Smaller Cylinder for Length?

Currently at base girth of 5.6 inches with slightly smaller midshaft and glans ~ 5.4. Was using a 2.O’ Leluv cylinder with flared base. I’ mainly aiming for length as girth comes naturally.

It takes me 30 mins of pumping at 5-7 mmHg with heat, to fill the pump, circumference wise. This is almost always with a huge donut beneath the glans. I’m hesitant to continue pumping with a donut and will end my session. My understanding is you have to fill the pump before going for length.

So, should get a smaller cylinder, at 1.75’. Might get in with lots of lube. Or should I just continue pumping with a 2’ CV cylinder past the massive donut?

Well if you have a massive donut you should use less hg.

And about the cylinder if you pack it in 30 minutes its gonna take less time every session.

I had the same problem order slightly oversize cylinder 2.25” then ordered another 2” cylinder.

When the 2” arrived I manage to pack it in less then 10-15min so I think you should stay with the 2” and hopefully after 1-2 months you will pack it in 5minutes :D .

Stay with the 2”

I’ve had the same issues with a lot of oversized and generic pumps (I’ naturally a big guy at 8.3” in length and 6.25” girth mid shaft). I still end up filling the tube with my girth but gain very little in length unless the pressure is so high that I end up developing blisters on my glands that leave marks for weeks. Is my best option to get a slightly small tube in diameter with plenty off length, like LeLuv offers?

I did the oppisite… i ordered 2.5 inch tube and am seeing length progress again…