Raw Tadalafil powder Cialis powder

So I am nearing the end of my first bottle(1gm/50ml).

I am noticing that because this is a suspension, when there is less liquid in the bottle there is still quite a bit of powder settling at the bottom. The taste has become increasingly bitter and the effects much more potent as I continue to dose.

This also leads me to believe that when the bottle was near full, I wasn’t getting as a high of a concentration. This would explain a lot of discrepancies concerning my reactions to the tadalafil/PGA mixture.

The only thing I can think of to ensure a more even dose when the bottle is full is to put the syringe close to the bottom when extracting even after shaking.

Another weird thing is that there is a crusty formation surrounding the neck of the bottle/where the top screws on. I am strongly assuming this is from a little bit of the powder evaporating and sticking to that surface area. This would mean that I’m losing some tadalafil from the overall mixture.

Could anyone recommend a good small(60-75 ml) bottle to use(that doesn’t have the crust action noted above happening)? The one I’m using now I got from an art supply store. It has a plastic cap, is made of glass and holds 60 ml.

You don’t say whether you have V or C. Your numbers equate to 20mg/ml. Did you make it yourself?

I usually start at the bottom and slowly move the syringe tip up as I draw, so that I get some liquid from all levels. This may be unnecessary, as I have gone through a couple of kitsnmore bottles, and never noticed a difference from beginning to end.

The powder doesn’t evaporate, the liquid does. What is happening? You shake your bottle, and the lid gets wet. When you put the bottle away the liquid portion evaporates leaving the powder behind on the lid. You aren’t losing any product however, as it is all staying on the lid. If you shake again, you will wash the crust back into solution.

A lid that is press in or press on (rubber stopper type like an injectable solution syringe bottle), may be better than a screw type, as the crust on the the threads may be more likely to fall out of the bottle, rather than falling back into solution, when you open it.

WHATS IS THE LIQUID?? I have recently been complaining about the quality of tadalafil and sinfindel I’ve ordered from the internet. I’ve ordered 5 grams of tadalafil and 5 grams of sildenafil citrate from Elite and it was of very low quality or which I though was very low quality. The tadalafil from Elite gave me a mediocre erection while the sildenafil gave me little to no results. I’ve just ordered liquid tadalfil spray which was flavored from cemproducts.com and I have to say it gave me one of the hardest erections I have ever had in my life. I was wondering if the solution that Kitsnmore and Cemproducts use for the tadalafil could be increasing the potency or maybe increasing the absorption of the tadalafil. Also Cemproducts was very fast with my shipping. I am going to order sildenafil spray from Cemproducts.com to see if that has any effect on me. All I know is that taking the raw powder without the liquid suspension does hardly nothing for me. I still have a lot of tadalafil left from my order from Elite and I was hoping to mix it with a solution similar to the one Cemproducts.com use in the tadalafil spray to see if indeed the quality of the Elite tadalafil is garbage or maybe the liquid is indeed increasing the potency or the absorption of the powder.

When did you order from elite? A little while back they had a different supplier from what I hear, and people didn’t seem pleased with it.

Dino puts Sildenafil spray from Cemproducts.com on his wish list, anybody else try this stuff?

I’d like to try it, but a little high priced in comparison to other places for sildenafil.

Liquid V (Sildenafil Citrate) 30 ML 25 MG/ML $65.95 w/shipping.

Got some other stuff too I’d like to try. Just a bit high in price, but if it works for ya, why not.

I did mention that it was a tadalafil/PGA mixture in my thread. I apologize though because it wasn’t a clear statement. I did make it myself at a 20mg/ml dosing. I used elitenet’s powder tadalafil and PGA(rum).

You are correct in that it isn’t the powder evaporating, but the mixture. The crust formation is happening on the outside threads, it’s not a lot(judging by how much is left in the suspension mix), but it is a very noticeable white/yellowish(the yellow I am assuming is from the rum) powder film.

I will have to try your recommendations with the two bottle options you have listed. The stopper type container sounds best.

Although these are just small observations/annoyances, overall the cost/benefit ratio concerning making one’s own tadalafil mix is outstanding!

Stormy, if you looking for a bottle with a rubber stopper as those for syringes, ask a pharmacist for advise and or ask for a similar air-tight type container. Tell him/her your making a mixture for herbs etc.

I know most of those little bottles for one shot liquors are 50+ ml’s.

And yes, the benefit of making your own liquid c from powder is a very, very good deal!

webslave, thanks for your advice on the powder tadalafil (i got mine 2 months ago). last night I checked my stuff out in the fridge, and my elitenet tadalafil also had some evaporation and was left with just the powder. I tried some last night and I think I took too much again (initial measurements a couple months ago were messed up). I am going to the store tonight so I will pick up a new 5th of vodka and try all of this again, so I don’t take too much (it sucks). I don’t have a syringe, so if anyone knows the amount of powder to put in a 5th, to leave you with: 1/2 shot= 1 dose of tadalafil. I’m going to have to do the math I guess

tadalafil is great for erect kegels, btw…

Invictus, you need to find yourself an air-tight bottle/container. The basic recipe is on my homepage, second page.

I recieved a shipment about a week ago from Elitenet. 2g Tadalafil.

Mixed it Sunday… Took a dose Monday.

DAMN! It works!

Giggidy Giggidy goo!

-Borat, his fanclub builds with each passing night

I’m glad to hear that, I was getting a little concerned with people getting varied product it seems, but your order was pretty recent so I feel better about it. I ordered the 18th and am waiting so we’ll see how it goes, if I get anything other than your good results, Ill post it, or I’ll probably be so excited I’ll post anyway.

Dammit, for a week now I’ve been checking the tracking and it just says the origin is preparing shipment. I guess that means it is still sitting in customs. The wait is killing me!

Yeahthatguy:

Don’t sweat it too much! If I remember correctly. My package sat for like 10 working days, then hit US customs, sat there ? Two days and was at my door in a few more days.

It said the same for me.

Trust in the system.

-Borat, the system works for him