Is there a way to target penis width? (Width not Girth)

Hi, I was curious if there are known exercises that target penis width heavily?
I’ve reached my length goals thanks to this forum, but my girth is around 4.5” and I’ve not been able to alter it even with months of dedicated routines. I regularly use jelqs for penis health and EQ, and I’ve tried consistent pumping and clamping routines with no change other than temporary puffiness. I’ve been at it over the years and for me it has been a waste of time, it is like my penis is steel and the only thing that is being affected by my efforts is the skin.

I finally gave up and accepted I have a smaller girth and put away my PE tools in storage, but very recently I started noticing my penis shape and it got me curious about targeting width, because it looks like mine is shaped to be flat and wide, maybe more so than average. I thought maybe I could try a routine to improve on what I do have and hopefully it will please my lady and get me motivated again to enjoy PE.
I recall seeing illustrations of the internal clit structure and it seems to indicate width size could be valuable for stimulating it even if you’re lacking a high total girth measurement.

My width measurement is 1.75”, maybe a little more, and I would like to fashion a routine to experiment and see if I can alter this width and increase it. I am purchasing a caliper to take more accurate measurements and track my progress if any.
Any and all input is much appreciated, thanks everyone.

It is pretty tough to cause cellular proliferation in just one direction. That being said, anything that can focus the outward pressure against the sides of your tunica rather than the top and bottom ought to work. There was a time I experimented with putting my semi-erect penis, roughly 60-70% erect, on a table top or chair, and would roll up and down on it with a rolling pin, the type you would use to roll out a pie crust. Sounds a bit funny, but I think it would definitely work for exerting pressure outward on that side to side axis. I didn’t really stick with it long enough to report any results, but I bet it would work.

What Ray said is basically the idea.

I have seen the rolling pin, people using a cock ring with flat palm on table or appliances, two pieces of wood and two clamps, any form of lateral compression. The problem stems from the fact that lateral compression can do a lot of damage very fast if you’re not careful. No one has calibrated exactly how much force it takes to cause width deformation so the chances of you overdoing it are high.

All of that being said, compression generally works fast if it works from what I’ve seen people say. Going for intensity sometimes can produce good results fast but it’s a hard call on how much force to apply at once.

I would look at the RedZulu Crusher and a few others. But I would recommend extreme caution.

If you’re buying a caliper and are already experienced pumping I recommend getting a elliptical thickwall cylinder since it allows to order a size height by width cylinder to focus on pulling laterally if you so choose

I got one and I enjoy it way more than the standard tube I had before. It even broke my plateau recently ( at least that’s what I’m crediting)