New to extending, how to set tension?

Hello

I have a JES extender. I’ve read its manual but I’m confused.

I compress the device then strap my stretched penis in.

When I release it stretches the penis but what about tension? I see all 3 marks.

I turn on screws and it just stretches the penis further.

To get to mark 1 I have to extend beyond my BPEL. I am 14cm BPEL and to get to mark 1 I have to stretch to like 15-16 cm.

Is this correct? Help please. I asked the chat on jes extender website and they said its safe to go beyond EL and that I should continue to add bars to outstretch the penis.

To control tension you have to turn the rods at the base, this increases or decreases load on the springs. This is manual.

This is a typical method of getting into the extender. When you release you are now in tension; however, it is very light, under 33% load if you can still see all three lines.

This is what should happen as you are now increasing tension.

At the one mark you are now at 33% tension. At the second mark 66%. I do not know how this equates to grams of tension because I am not familiar with what the max load is of the JES system.

How does it feel?

This thread might provide you some insight.

Some guys say in this forum that extending beyond EL is a bad idea and that it can be harmful but also that the penis must be under tension.

It’s just that I cannot reach mark 1 without stretching like an inch more than my EL. And I don’t know if that’s how it should be or not.

It feels kinda ok, maybe too much of a stretch if I reach mark 1. I have peyronie’s disease too my penis curves 45 degree to the left.

I am a newbie as well but your BPFSL Bone Pressed Flacid Stretched Length is usually longer than your BPEL Bone Pressed Erected Length. It seems that you first get gains in BPFSL and this makes space for BPEL changes to follow. It still might take time for the BPEL to catch up to the gains of BPFSL. If you gain 1/4” in BPFSL you will probably not gain 1/4” in BPEL and will gain less than 1/4”. The BPFSL can be 1/2 longer than your BPEL, give or take.
Some people do not pull hard enough to get a true BPFSL measurement. Everyone is different, some people need a half inch gap between the two measurements before they achieve cemented growth in BPEL. Some need a bigger gap and some need a smaller gap.

Keep searching the forum, there is a ton of information here.

Use a lot of heat, drink a lot of water, monitor your PIs, be consistent…

Good Luck on Your Journey….

Thanks for the info guys.

1Warrior, you are doing it correctly, and you’ve got the right answer from the JES website - add more bars if the extender can not extend to the length your penis will extend to. There’s no problem in extending beyond erect length, it is just the way your penis is. The lines on the extender equals 600/900/1200/1500 grams of traction.

Go for it !