Right way to calculate length?

I just wonder when people put the ruler on top of penis do you press the ruler to the bone or lightly to flesh? because if you press it hard to bone you get some extra length. Ive noticed if I press to the bone I can get it almost around 6.7inch (hmm.. I think Ive already gained a bit :) ) if this’s correct way to calculate then I think Ive quite good thing going and coming with the length .. but I guess I need girth more than length. Do you take the girth from the head or middle? Cross-section is only around 1.58” in erection I need it more wide :)

Bone pressed is pretty much the standard for length, as it gives everyone the same datum point and eliminates the fluctuation in fat pad thickness. Girth is generally taken from around the middle. Make sure to take girth as a circumference, not a diameter.

Yeah thanks, that makes sense.. then Ive always calculated it too short :) Even when I didnt notice the zero point started at around 0,3inch not at 0 :D … I gotta recheck the length.. No wonder I thought that average length should be quite monster if I had less than average or average when I calculated it wrong ;P

I just didnt press near bone because thought it could be cheating good to hear its the right way :)

I guess I have the same question. How hard do you press to get a good measurment?

I thought I was average or below in length but using this method I measure 7.5 length

and 5.5 around. Does not seem right to me. How many and how often should someone

just starting out do the “milking”?

I dont really trust BPEL measurements that much it varies a lot according to the erection you had at the time. For example if i have a common erection i ´d measure around 6.5” but if i get a super erection (: p rarely) it ´d go all the way to 7.2”

Then I would work on getting more super erections!!!

haha DremelGawd your erections get ‘round 5 inch at your best!..and when you have preocupations in mind…..better dont talk….2 or 3?? hehehe

PS:humorrrrrrrr